Body Lift ... location of fixings
Discussion
Hi all, new here and new(ish) to Chimps.
I took my 4.0HC engine out to replace with a new 4.6 with all the goodies on ... then I took the measly brakes off to replace with better ones ... then I took various interior pieces out to freshen that up and verrily, there was not much left.
A very nice geezer in Chepstow has quoted to strip the chassis and repaint, repairing outriggers if necessary etc and I would like to deliver it to him ready to lift the shell. I've counted 14 bolts in the floor, 2 behind the rad and perhaps 4 behind the tank but I've yet to remove that. The 6 seat-belt bolts are already out so does anyone know if there are more of the miserable rusty beggars to get out?
Cheers,
Sam
I took my 4.0HC engine out to replace with a new 4.6 with all the goodies on ... then I took the measly brakes off to replace with better ones ... then I took various interior pieces out to freshen that up and verrily, there was not much left.
A very nice geezer in Chepstow has quoted to strip the chassis and repaint, repairing outriggers if necessary etc and I would like to deliver it to him ready to lift the shell. I've counted 14 bolts in the floor, 2 behind the rad and perhaps 4 behind the tank but I've yet to remove that. The 6 seat-belt bolts are already out so does anyone know if there are more of the miserable rusty beggars to get out?
Cheers,
Sam
On the Griff
There are twenty two chassis bolts in total.Four are in the boot, two are below the radiator and sixteen are in the cabin.
Boot - Remove the four rear chassis fasteners, two M10 hex socket screws and two upper dome head cap screws (6mm Allen key).
Engine Bay - Remove the two M10 hex socket set screws just below the front ARB mounts. On my car the offside mounting was also an earth point.
Cabin - There are eight floor bolts on each side and in true TVR style some of the nuts are captive and some aren’t. Lifting the carpet over them will expose the heads enough to remove.
Drivers side -There are two M10 set screws at the rear, three mid floor, two by the pedals and one above the transmission tunnel.
Passengers side - There are two M10 set screws at the rear, three mid floor, two in front of the battery box and one above the transmission tunnel.
http://www.thegriffithpages.com/modifications/chas...
There are twenty two chassis bolts in total.Four are in the boot, two are below the radiator and sixteen are in the cabin.
Boot - Remove the four rear chassis fasteners, two M10 hex socket screws and two upper dome head cap screws (6mm Allen key).
Engine Bay - Remove the two M10 hex socket set screws just below the front ARB mounts. On my car the offside mounting was also an earth point.
Cabin - There are eight floor bolts on each side and in true TVR style some of the nuts are captive and some aren’t. Lifting the carpet over them will expose the heads enough to remove.
Drivers side -There are two M10 set screws at the rear, three mid floor, two by the pedals and one above the transmission tunnel.
Passengers side - There are two M10 set screws at the rear, three mid floor, two in front of the battery box and one above the transmission tunnel.
http://www.thegriffithpages.com/modifications/chas...
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


