Drive shaft end float - what's the problem?
Discussion
I'm currently rebuilding the front suspension, steering,radiator and nose cone on a Chim 5.0. When I removed the exhaust system to allow access to repaint front of the chassis, a closer inspection of the drive shafts revealed some problems. Both gaiters on both sides split and a huge amount (15-25mm)of 'end float' in the drive shafts.The symptoms are likely to be connected, ie split gaiters allowing accelerated wear. Question/help though is about cause of 'float'? Is it likely to be one or both CV joints OR the differential unit.
I had planned to overhaul he front end and get the car back on the road this summer and refurb the rear over next winter. Sounds like I don't have an alternative though. Any thoughts suggestions. If the drive shaft itself hasn't sheared the splines and isn't broken should it be the CV joints only.
Many thanks
Mac
I had planned to overhaul he front end and get the car back on the road this summer and refurb the rear over next winter. Sounds like I don't have an alternative though. Any thoughts suggestions. If the drive shaft itself hasn't sheared the splines and isn't broken should it be the CV joints only.
Many thanks
Mac
mackenzie said:
a closer inspection of the drive shafts revealed some problems. Both gaiters on both sides split and a huge amount (15-25mm)of 'end float' in the drive shafts.
Sounds like you need a new set of seals. Bad news it's a bit of an awkward job removing the shaft from the vehicle; good news that once you have access to do one end, it's no more effort to replace both ends - and the gaiters themselves are very cheap. Don't worry about the end float, but do worry whether the CVs may have suffered wear due to the grease all leaking out through the splits gaiters. Check for torsional play before refitting. CVs are also relatively cheap, and if in doubt you'd want to replace all four while you have everything apart rather than put dodgy ones back on.Do you mean float or do you mean plunge? There is float in that the joints sit between circlips on a grooved land on the shaft but 20+mm sounds too much. There is easily that much 'plunge' in the joint however, which is just a function of how it works. If the latter, it's doing what it should. Rotational play and 'graunchiness' is the symptom of problems.
If joints are needed, try DaveMac propshafts in Coventry
If joints are needed, try DaveMac propshafts in Coventry

Gassing Station | Chimaera | Top of Page | What's New | My Stuff


