temperature guage
Discussion
my temperature guage as just stopped working , can any one tell me where the sensor is located on the serp engine and how do i go about testing it .don`t know if its a coincidence or a wire as been damaged due to the new front bottom wish bones being fitted . the needle is hard down to the left and there is no movement .
Sensor is on front of engine hidden behind the distributor. If you pull the single connection off and ground it to the engine the guage needle should move right round to the right. If it does then the wiring and guage are ok. but the sensor is duff. If not then the wiring or guage could be suspect, but the sendor ok.

+1
Pretty straightforward job to change if the sensor is duff:
debaron said:
Dizzy out is the best way to get to the sender unit on the Serp. Mine is also reading low intermittently but the fans cut in now and again regardless of what's on the gauge so will change it.
Simple job - 45 mins.
PAS hose securing clip off (if fitted) - 10 mm ring spanner
14 mm Ring spanner to loosen Dizzy clamp
Twist dizzy when loose to get hand in and remove bolt and clamp
Pull dizzy off - stuff big rag in the hole! Don't want any junk (or water) getting into the engine!
The sender is then right there in front of you. I'd imagine water will come gushing out of the sender hole when removed so make sure you have a rag to stop it getting into the dizzy hole.
New one in and connect up. Dizzy back in and away you go. Obviously pay attention to exactly where the rotor arm is pointing and also mark the dizzy housing against the engine before removal so you can line up when refitting.
Hope this helps!Simple job - 45 mins.
PAS hose securing clip off (if fitted) - 10 mm ring spanner
14 mm Ring spanner to loosen Dizzy clamp
Twist dizzy when loose to get hand in and remove bolt and clamp
Pull dizzy off - stuff big rag in the hole! Don't want any junk (or water) getting into the engine!
The sender is then right there in front of you. I'd imagine water will come gushing out of the sender hole when removed so make sure you have a rag to stop it getting into the dizzy hole.
New one in and connect up. Dizzy back in and away you go. Obviously pay attention to exactly where the rotor arm is pointing and also mark the dizzy housing against the engine before removal so you can line up when refitting.
Ryan
Not if you pay attention to a few things.
Firstly, get a long flat head screwdriver and position it so half of the head is on the dizzy base and half on the engine casing directly below the dizzy base.
Next, give the screwdriver a little tap so it makes a mark in the engine casing and the dizzy base at the same time. Now you have a point that you can twist the dizzy base to in order to re-align the timing.
This ONLY works when the following is observed - The rotor arm needs to be pointing to the same place that it was before removal.
Take the cap off and photograph or mark where the arm points. When I did mine the arm was directly in line with one of the clips that hold the cap on. You can also mark the arm position on the black plastic cover under that says 'Do Not Remove'. I did this too for double checking.
Because of the relatively small number of teeth on the dizzy drive, it will either go back in noticeably before, after or exactly on your markings.
Worked fine for me. Twice.
Sounds like someone has replaced the sensor with an incorrect one and tried to recalibrate. Unfortunately this is a common misconception and it does not work that way. You need the correct sensor. All the resistor will do is give a correct reading at say 80 deg, but all other temperatures will read wrong.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


