Oil Pressure Sender Location
Oil Pressure Sender Location
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Thursday 23rd April 2009
quotequote all
Just a quick one to ask where the Oil Pressure Sender is situated on a Serp and how easy is it to get to/change.

Cheers


Ryan

Edited by debaron on Thursday 23 April 11:44

duncscz

262 posts

282 months

Thursday 23rd April 2009
quotequote all
Assuming you can get the car up on some axle stands or a ramp, it's easy to change. It's situated towards the back of the engine and you'll need to be well under the car to reach it. Remove the spade connector and unscrew the unit (3/4" spanner if I remember). 'They' say no oil should be lost when swapping, but it pi@@ed out when I changed mine, which makes it a slippery job to screw the new unit in (so wear gloves). Various ideas about how best to seal the new unit - I used PTFE tape (but I still think it's weeping slightly) .. so I may have to try again with some Blue sealant.
Good luck ...

Crazycraig

485 posts

262 months

Thursday 23rd April 2009
quotequote all
debaron said:
Just a quick one to ask where the Oil Pressure Sender is situated on a Serp and how easy is it to get to/change.

Cheers


Ryan
Here's an image for clarity.


debaron

Original Poster:

878 posts

228 months

Thursday 23rd April 2009
quotequote all

Thanks Craig - very nice looking chassis by the way....