How to select reverse gear?
How to select reverse gear?
Author
Discussion

Whiplash

Original Poster:

301 posts

243 months

Saturday 25th April 2009
quotequote all
If I go from 5th straight back into reverse all seems ok but......

If I select reverse from neutral I get this almighty cluncking noise.

Is this a warning sign for my wallet or is this normal?

Oh and it's the T5 box.

GreenV8S

31,027 posts

315 months

Saturday 25th April 2009
quotequote all
Yes that's normal. There's no synchro on reverse, so if the clutch has been engaged with the engine running the lay shaft needs to be brought to a halt by engaging any forward gear before you put it into reverse. I tend to use 1st, because it's the only synchro that's never used in anger.

Edited by GreenV8S on Saturday 25th April 15:13

Whiplash

Original Poster:

301 posts

243 months

Saturday 25th April 2009
quotequote all
Thanks Green. Just went out and tried 1st to reverse and it was nice and smooth.

Is it ok to leave the car in gear when parked?

clarkmagpie

3,714 posts

226 months

Saturday 25th April 2009
quotequote all
hightly recommend leaving the car in gear when parking

found out to my cost that the handbrakes are bloody crap!!

Noogly

424 posts

301 months

Saturday 25th April 2009
quotequote all
Leaving the handbrake on for a while (weeks) will probably cause it to stick to the discs anyway, so I always leave it in gear if I'm not planning on using it for a few days and handbrake off (on the flat obv)

Never considered 1st - reverse, I always user 3 or 5, but 1st makes sense.
My car needed a rebuilt box when I got it (40k miles) as synchro on 5th was shot, I thought that would be unusual, but the garage said if the T5 box goes it is usually 5th. Maybe T5s get a disproportionate amount of use on 5th synchro due to this.
I'll use 1st from now on!