Powerflex Poly Diff Bush
Powerflex Poly Diff Bush
Author
Discussion

CaptDaveRobinson

Original Poster:

42 posts

215 months

Wednesday 29th April 2009
quotequote all
Just a quick one. Has anyone got any good ideas for fitting a new powerflex bush back into the chassis itself?

I pushed the ones in on the plates using a vice but cant do that on the main chassis.

HRG

72,863 posts

270 months

Wednesday 29th April 2009
quotequote all
Void bush tool, loads of socket extensions, plenty of copper grease and liberal amounts of swearing...

http://www.tridon.com.au/Products/Product.aspx?SG=...


spend

12,581 posts

282 months

Wednesday 29th April 2009
quotequote all
I use a length of studding, large socket and a big washer I cut myself (minor dash gauge hole IIRC hehe). Warm it up in water (kettle), dry off, spray with lube and quickly wind it in... Still needed the studding to wind the bearing in (part ii). It all goes in nice & tight, just make sure it all sits centrally.