Coil Replacement?
Discussion
I have been having an issue with my 94 4.0 Chim (one of many) whereby the car has been cutting out and running very rough. When I get above 3500 rpm it can often be hesitant.
An alarm specialist has looked at the car and suggested that I need to have the coil replaced. Can anyone point me to the correct replacement part?
Is this a difficult job or will I have to put it into a garage to replace? I don't mind getting my hands dirty providing it requires relatively no skill!
Cheers and thanks again in advance for all the info you guys provide!
Aidan
An alarm specialist has looked at the car and suggested that I need to have the coil replaced. Can anyone point me to the correct replacement part?
Is this a difficult job or will I have to put it into a garage to replace? I don't mind getting my hands dirty providing it requires relatively no skill!
Cheers and thanks again in advance for all the info you guys provide!
Aidan
http://www.racetechdirect.co.uk/product-subsection...
http://www.tvrcarparts.com/pages/parts.asp?vehicle...
http://www.clever-trevor.net/part/103/ignition-coi...
I went for the last one i think i got mine a bit cheaper from ebay. Its very straight forward job can do it your self takes 10mins ish
http://www.tvrcarparts.com/pages/parts.asp?vehicle...
http://www.clever-trevor.net/part/103/ignition-coi...
I went for the last one i think i got mine a bit cheaper from ebay. Its very straight forward job can do it your self takes 10mins ish
Edited by scotty_d on Thursday 30th April 11:15
aidanbree said:
Thanks for the part number Chris!
My local parts supplier has an Intermotor one for 22 quid. I presume that this will do the job? Any major difference between this and a Bosch?
Dont use Inter*otor they are sMy local parts supplier has an Intermotor one for 22 quid. I presume that this will do the job? Any major difference between this and a Bosch?
te,just go with the Bosch unit you get what you pay for,and yes i speak from many years in the M/Trade
never cut corners with things like this it will leave you stranded
pay now or pay later 
Edited by Simon Says on Thursday 30th April 13:05
Tried TVR Power however they no longer stock the Bosch unit. They suggested they had a non-branded but manufactured by the same people who make the Bosch coil however they didn't have it in stock. I was a little wary at that....
Famous Four had it in stock and I think it was delivered this morning (unfortunately at work!)
Will have a go at fitting (noting polarity) over the weekend
Thanks again folks
Cheers
Aidan
Famous Four had it in stock and I think it was delivered this morning (unfortunately at work!)
Will have a go at fitting (noting polarity) over the weekend
Thanks again folks
Cheers
Aidan
Simon Says said:
aidanbree said:
Thanks for the part number Chris!
My local parts supplier has an Intermotor one for 22 quid. I presume that this will do the job? Any major difference between this and a Bosch?
Dont use Inter*otor they are sMy local parts supplier has an Intermotor one for 22 quid. I presume that this will do the job? Any major difference between this and a Bosch?
te,just go with the Bosch unit you get what you pay for,and yes i speak from many years in the M/Trade
never cut corners with things like this it will leave you stranded
pay now or pay later 
Edited by Simon Says on Thursday 30th April 13:05
MADMAX2 said:
Al 450 said:
have u got the link and the exact price al?cheers
ian
£43.70, not cheap but as I mentioned it's shiny!!
A word of caution about the flame thrower coil, there is a past post where a guy had all sorts of problems with one, and the problem is the RV8 system has a resistance wire feeding the coil, so you only normally see about 9 volts. I dont know how the flamethrower coils cope with ballast resistors, as they come in various primary impedences. Basically the lower the resistance, the more current the coil draws, (More power) but with a ballast resistor the more voltage is dropped as the coil resistance drops, so you might only end up with say 6 volts, which will compleatly destroy the reason for having a higher voltage coil in the first place. You could feed it with a 12 volt supply, but Id expect this to exceed the ignition amps switching ability fairly rapidly.
Mark
Mark
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




