Discussion
Can the collective give me the ride height measurement and datum from where you measure for the Chim?
Just had new GAZ golds fitted, and 600 miles on, I guess the springs have settled. I'd like to raise the platforms to adjust ground clearance and need some guidance.
As a comment I can barely get 2 fingers between tyre and wheel arch.
Just had new GAZ golds fitted, and 600 miles on, I guess the springs have settled. I'd like to raise the platforms to adjust ground clearance and need some guidance.
As a comment I can barely get 2 fingers between tyre and wheel arch.
The search facility must have pages of hits on this topic.
From corner of outrigger to the ground on very level sueface, 150mm front 160mm rear. When done drive and test again. Also check by turning the car to face the opposite direction. If there's a difference then the ground was not level enough
From corner of outrigger to the ground on very level sueface, 150mm front 160mm rear. When done drive and test again. Also check by turning the car to face the opposite direction. If there's a difference then the ground was not level enough
after fitting Gaz G I had same issue...partly cos i did trip to south france with all but kitchen sink in boot and drove it hard. It wouldn't get over anything it had sunk so low. Had it reset but kept it slightly lower than standard as handling and looks are better ...but speed bumps a pain still
When touring I always load the car up and then set the ride height for the extra weight, makes a much better compromise IMHO.
Just have little block of wood with marks for the ride heights you require, you can tweak them quick enough if you need to. This flat surface, to the nearest mm is all a bit silly when the loadings will make much greater differences... You only need to be anal like that if you are trying to refine very specific settings, which I suspect very few people are interested in that level of detail. Predicting the load to set up for will yield much better results IMO.
Just have little block of wood with marks for the ride heights you require, you can tweak them quick enough if you need to. This flat surface, to the nearest mm is all a bit silly when the loadings will make much greater differences... You only need to be anal like that if you are trying to refine very specific settings, which I suspect very few people are interested in that level of detail. Predicting the load to set up for will yield much better results IMO.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



