Bonnet wonky- what happens if I unscrew this?
Discussion
Dear all,
My bonnet is slightly wonky, being lower at one side by 1-2cm than the other.
The reason for this is that rather than sitting on both of the bonnet 'rests' on the inside of the wings, the bonnet 'edge' has bent slightly and is sitting on the inside of the RH bonnet rest instead of on it, causing that side of the bonnet to sit lower than the other side.
In case you're wondering what on earth I'm talking about- here's a pic below

This is now causing one of the bonnet cross braces to be worn away by the alternator- (See below- the 'wedge' worn away)

Now I believe, that if I can insert a spacer into the bonnet rest to make it sit further inboard, the RH edge of the bonnet will rest on it again instead of beside it, bringing the bonnet back into line and curing the problem- however before I unscrew the bonnet rest- does anyone know whether its screwed in, or bolted? - ie if I unscrew it will a bolt fall off somewhere in the wing, probably never to be found again- or is it just screwed into the glass fibre?
Not sure why its taken me so many words =^ to basically ask 'is the bonnet rest screwed into the fibreglass or bolted?', but hey ho...
My bonnet is slightly wonky, being lower at one side by 1-2cm than the other.
The reason for this is that rather than sitting on both of the bonnet 'rests' on the inside of the wings, the bonnet 'edge' has bent slightly and is sitting on the inside of the RH bonnet rest instead of on it, causing that side of the bonnet to sit lower than the other side.
In case you're wondering what on earth I'm talking about- here's a pic below

This is now causing one of the bonnet cross braces to be worn away by the alternator- (See below- the 'wedge' worn away)

Now I believe, that if I can insert a spacer into the bonnet rest to make it sit further inboard, the RH edge of the bonnet will rest on it again instead of beside it, bringing the bonnet back into line and curing the problem- however before I unscrew the bonnet rest- does anyone know whether its screwed in, or bolted? - ie if I unscrew it will a bolt fall off somewhere in the wing, probably never to be found again- or is it just screwed into the glass fibre?
Not sure why its taken me so many words =^ to basically ask 'is the bonnet rest screwed into the fibreglass or bolted?', but hey ho...

Gassing Station | Chimaera | Top of Page | What's New | My Stuff


