Help Please, Oil Pressure Gauge Problem,
Help Please, Oil Pressure Gauge Problem,
Author
Discussion

Swanni

Original Poster:

34 posts

214 months

Sunday 3rd May 2009
quotequote all
Started the chim today, noticed the oil gauge was not registering, it was fine yesterday. Turned ignition on, oil light came on, started engine, oil light went off, still gauge not registering. However after stopping engine and turning ignition back on the gauge shows about 30 psi and drops gradually. An electrical poblem I hope, any suggestions where to start, I am hoping to go to Shuttleworth airshow later today. Thanks

selnic

467 posts

298 months

Sunday 3rd May 2009
quotequote all
Sounds like a bad connection at the sender, try pulling the connectors off the sender and cleaning them with a piece of wire wool - sender is located near to the oil filter.
HTH

Swanni

Original Poster:

34 posts

214 months

Sunday 3rd May 2009
quotequote all
selnic, taking your advice, went for the ramps, hmmm, not in garage, strange, never lend things out, will get under car tomorrow. Thanks

selnic

467 posts

298 months

Sunday 3rd May 2009
quotequote all
Should still be OK to use for today, as the oil pressure light is going out thus indicating no real problem with the engine, it's just nice to be able to see what is happening on the gauge.