Front Lower Wishbones
Front Lower Wishbones
Author
Discussion

churst

Original Poster:

27 posts

225 months

Monday 4th May 2009
quotequote all
I have just replaced front lower wishbones after strip and paint. Re-assembled both sides and awaiting delivery of new drop links and track rod ends before final set up and everything torqued.
Question: how on earth do you get a socket and torque wrench to fit on the 2 x chassis bolts and
1 x lower shocker bolt. Both rears and front uppers were not to bad access wise and managed to torque to correct values. Are these bolts on the front lower to be tightened by hand or is there some
special seceret to getting in with a socket and torque wrench.
Went to my first Chatsworth gathering last week, one word to describe AWESOME.
Well done to everybody concerned.
Tried to twist the wifes arm in getting a Tuscan or T350, not a chance.

Col

dogbucket

1,256 posts

232 months

Monday 4th May 2009
quotequote all
Being Nyloc nuts not too much of an issue to get exactly the right torque I would think. I cannot believe the bottom shock mount was ever done with anything other than a pair of spanners as nothing else will fit.

haircutmike

22,511 posts

235 months

Monday 4th May 2009
quotequote all
+1, Spanners are fine as they are nyloc nuts, just use common sense.

Peter.