To crank or not to crank - oil pressure worries
To crank or not to crank - oil pressure worries
Author
Discussion

schmokin1

Original Poster:

1,223 posts

243 months

Tuesday 5th May 2009
quotequote all
My chim has been laid up for a long while and tonight was the night to get it going. I tried to prime the oil pump by the squirting oil back up the centre method, then disconnected fuel pump wires and coil main lead and turned it on the starter.

The oil pressure light didn't go out after 10 seconds or so of turning and no pressure registered on the gauge. Will I damage the engine by crankin it some more? Should i fire it up for a few seconds o see if the pressure comes up? How long is too long with no oil pressure?

Obviously I'm petrified I'll shag the engine if i run it too much without pressure....

Help please, I've worked for months to get to this stage and I need my chim!!

Mad Mitch

842 posts

259 months

Tuesday 5th May 2009
quotequote all
My Chim sat from the 30th November last year untill last Tuesday. Dead battery etc. Booster box on and fired up first turn of key and oil light went off instantly. These engines, although not high oil pressure flow a lot of oil. Just fire it up and it should go straight out. We are all guilty on occasions of worrying too much when there is usualy no need.

Steve.

schmokin1

Original Poster:

1,223 posts

243 months

Tuesday 5th May 2009
quotequote all
Hi Mitch
When I say it has been laid up a long time I am talking years (bought it as a non runner)and I didn't know about the oil pump draining if you leave it without oil in it, so I am sure the pump needs priming. Just worried if i crank it and the light stays on will I knacker it, and how long should I wait (engine running) before switching of if the light stays on...

Cheers
Schmo

GreenV8S

31,027 posts

315 months

Tuesday 5th May 2009
quotequote all
The bearings will still be oiled. I'd get it fired up and then fast idle it for 5 seconds or so, if it hasn't got oil pressure by then it probably isn't going to.

spend

12,581 posts

282 months

Tuesday 5th May 2009
quotequote all
Is it a pre-serp first of all? Serps much more a case of fire it up and keep fingers crossed rofl

Squirting oil in the oil switch hole is much more effective than up the oil filter, even better in the pressure relief valve (that really does prime the input to the oil pump).

I found it did take about 20-25secs on the starter to get pressure, not something I would want to do too often (my starter kind of objected to that continual treatment hehe)

You can pull the dizzy on a preserp and spin the oil pump drive with a drill if you have a problem..

schmokin1

Original Poster:

1,223 posts

243 months

Tuesday 5th May 2009
quotequote all
it's a pre serp early 94 car (400)

OK I'll fire it up for a few seconds and see what happens. If no joy, is it the guage sender I need to take out and squirt oil into or the warning light sender?

BTW I have three warning lights on the dash between the speedo and rev. Bottom one I think is the oil pressure light (red), middle one is amber and I'm assuming this is charge light. Top one is red but hasn't come on at all when ignition is on. Can anyone tell me what it is?

cheers
schmo

steve-V8s

2,924 posts

279 months

Tuesday 5th May 2009
quotequote all
Have you taken the filter off and filled it ?

K4TRV

1,819 posts

283 months

Tuesday 5th May 2009
quotequote all
schmokin1 said:
it's a pre serp early 94 car (400)

OK I'll fire it up for a few seconds and see what happens. If no joy, is it the guage sender I need to take out and squirt oil into or the warning light sender?

BTW I have three warning lights on the dash between the speedo and rev. Bottom one I think is the oil pressure light (red), middle one is amber and I'm assuming this is charge light. Top one is red but hasn't come on at all when ignition is on. Can anyone tell me what it is?

cheers
schmo
I think the top is your alarm LED
The middle yellow is the oil.
The bottom red is the alternator.

Regds

Trev

schmokin1

Original Poster:

1,223 posts

243 months

Tuesday 5th May 2009
quotequote all
hi all

well I fired it up and the oil gauge sprang into life, shortly followed by all the dash lights extinguishing.

Top warning light still dead but as i have an aftermarket alarm this would be no surprise.

so all is well although it was hunting on idle. however I need to take it for a blast before drawing any conclusions.

Now to work out why I have no dipped beam headlights (see other thread)!