Small Hole In Induction Pipe.
Small Hole In Induction Pipe.
Author
Discussion

teamrecon

Original Poster:

154 posts

220 months

Tuesday 5th May 2009
quotequote all
Hi everyone,

Whilst under the bonnet the other day, I decided to remove the elbow pipe from the plenum to the AFM. I noticed that on the underside was a small hole, that you could see daylight through when looking down the pipe.

Could someone with some more knowledge than me, tell me if this would effect running, fuel consumption etc ??

The car seems fine, but just thought I'd ask !

Cheers in advance

Neil

dogbucket

1,256 posts

232 months

Tuesday 5th May 2009
quotequote all
Not good I would say as it means air is being drawn into the engine that is not going through the AFM so it will no longer be reading true.

Replace it with a smooth bore elbow pipe from ACT and you might get a modest power increase as well.

selnic

467 posts

298 months

Tuesday 5th May 2009
quotequote all
If the hole is between the AFM and plenum it will allow un metered air into the engine, thus causing the engine to run lean. It will also mean that it is drawing in air which has not been filtered. In short get it changed asap before it causes any damage.
HTH
Nick

teamrecon

Original Poster:

154 posts

220 months

Tuesday 5th May 2009
quotequote all
Thanks for the replies. Smooth bore elbow on order smile


Neil


Edit : Thanks for the comment on the unfiltered air Nick, I hadn't thought of that.. eek

Edited by teamrecon on Wednesday 6th May 14:37

teamrecon

Original Poster:

154 posts

220 months

Saturday 9th May 2009
quotequote all
Quick update.

I ordered the smooth bore elbow from ACT and fitted it last night. Even with my limited skills was a straightforward job, with just a little trimming required.

Took the car our last night and this morning and what a difference !! I thought the car was ok before, but now I have seen the light. Much smoother and more responsive.

Thanks for the advise and comments everyone.

Neil