Coolant Thermistor out of range!
Coolant Thermistor out of range!
Author
Discussion

scotty_d

Original Poster:

6,795 posts

225 months

Wednesday 6th May 2009
quotequote all
I have just received my new code reader there, plugged it in and this code came up 14 Coolant Thermistor out of range. I take it this is the main coolant temperature sensor? If so i only replaced this last year or may i used the wrong one With different values? The both looked the same so a little confused.

Cheers Scotty

chrispitman

742 posts

285 months

Wednesday 6th May 2009
quotequote all
The ECU Temp sensor is the one near pass pump it has a two pin connection, the other one in the V behind dizzy with single wire is the gauge. I think in the steve heaths bible it lists the resistance for the ecu temp sensor so you could check with a meter.

blitzracing

6,422 posts

251 months

Wednesday 6th May 2009
quotequote all
Check for 5 volts across the connector pins (disconnected from the thermistor) with the ignition on. This will prove that the loom is not open circuit and generating the error.

scotty_d

Original Poster:

6,795 posts

225 months

Wednesday 6th May 2009
quotequote all
I am heading up to dreadnought in the morning with the car anyway to get my geometry done (at last) so will get them to have a look while it there. too wet to check just now as my car is out side just now.

scotty_d

Original Poster:

6,795 posts

225 months

Wednesday 6th May 2009
quotequote all
Well just got really wet but have found that there is 5v on the multi plug to the sensor and that the multi plug is missing the metal clip that give a tight fit so the plug was a little loose could be my problem.

scotty_d

Original Poster:

6,795 posts

225 months

Wednesday 6th May 2009
quotequote all
I should look at the Obvious before posting it was the metal clip that was missing that was allowing the plug to come off with vibration i fixed it with a paper clip just like the A TEAM would laugh. My question is what is the effect on the cars running with out this sensor plugged in IE. fuel consumption ect?

Edited by scotty_d on Wednesday 6th May 18:06

blitzracing

6,422 posts

251 months

Thursday 7th May 2009
quotequote all
It may have overfuelled somewhat, but then the ECU may have dropped onto the "get you home" fuel map. I have only tested the range of the temp sender uo to 1k ohm extra, and then the ECU could not longer control the mixture accurately any more. Below this valuethe Lamdba feedback kept things fairly much in range .