Lost another of my CCC's
Discussion
well yesterday wasn't a good day, came out to load up the Tuscan everything seemed fine, drove off home and after a short way noticed what sounded like a flat tyre, got out to see what turned out to be about a 5" nail sticking in my tyre, I'm assuming it was put under the tyre on purpose as something that big doesn't really go it so straight, It's bent over in the tyre as its so long and then rubbed the sideway so the new tyre which was on 3 weeks is scrap.
Then travelling home I lost a exhaust can as well, properly my fault as stripped the thread out the other side clamp trying to do up tight so must have left this side a little too loose.
So if anyone has a pair of cans knocking about let me know, I've placed a wanted ad in the classifieds so will see what turns up.
Then travelling home I lost a exhaust can as well, properly my fault as stripped the thread out the other side clamp trying to do up tight so must have left this side a little too loose.
So if anyone has a pair of cans knocking about let me know, I've placed a wanted ad in the classifieds so will see what turns up.
Noisy, that is bad luck, i have a pair of standard (carbon finish) cans from a T2 in the garage, there are some mallet marks at the rear of the cans as they were hard to remove, you are welcome to have a look if you are interested, they can also be sleeved for more noise, going cheap!
Noisy said:
Tamster I've sent you a mail 
Will maybe need some sleeving too, although if you tell me the size Partco do lengths rather cheap I believe.
Noisy, YHM, sleeving diameter is 51mm and length of tubing is 400mm if memory serves me correct, you can use aluminium or titanium, usually available on Fleabay Will maybe need some sleeving too, although if you tell me the size Partco do lengths rather cheap I believe.
I may have a set of nearly new CCC's as I am thinking of getting the RG oval pipes. I need to check the condition of my exhaust first to make sure it is strong enough and in good enough condition to take the oval pipes. I will know for sure at the end of next week. I will PM you next week if interested.
Gassing Station | Tuscan | Top of Page | What's New | My Stuff