Broken Ball Joint Spindle
Broken Ball Joint Spindle
Author
Discussion

CaptDaveRobinson

Original Poster:

42 posts

215 months

Saturday 9th May 2009
quotequote all
Hi Guys, I have broken something else! This time it is the front spindle that holds the top ball joint to the hub. Does anyone know where I can get a replacement?

spend

12,581 posts

282 months

Saturday 9th May 2009
quotequote all
Do you mean the ball joint has broken???

The ball joint bolts directly to the hub casting, they are'nt expensive - but replace in pairs as usual.

CaptDaveRobinson

Original Poster:

42 posts

215 months

Saturday 9th May 2009
quotequote all
No the ball joint is stuck in the spindle of the casting. So I took the spindle out so that I could press the ball joint out; but it broke the spine with the hose holes off the back of the cast spindle

GreenV8S

31,027 posts

315 months

Saturday 9th May 2009
quotequote all
spend said:
The ball joint bolts directly to the hub casting, they are'nt expensive - but replace in pairs as usual.
They bolt to an adapter that is clamped to the top of the upright. The adapter is a censored off solid casting and it's hard to see how you would break it. I've given mine a right walloping in the past while changing the ball joint, and it seems none the worse for it.

GreenV8S

31,027 posts

315 months

Saturday 9th May 2009
quotequote all
CaptDaveRobinson said:
No the ball joint is stuck in the spindle of the casting. So I took the spindle out so that I could press the ball joint out; but it broke the spine with the hose holes off the back of the cast spindle
Either weld the broken bit back on, or cut (get somebody to cut for you) a new one and weld that back on. Or don't bother. That little tab is not exactly mission critical, is it?

CaptDaveRobinson

Original Poster:

42 posts

215 months

Saturday 9th May 2009
quotequote all
I am in the Army; if you were to put me in a completely round room with no doors or windows and nothing in it but two solid metal balls, and leave me for ten minutes, when you came back I would have broken one of the balls and lost the other.

They haven't invented something that I can't break.

Thanks for the advice. Will be more careful next time. Worse thing is I still didn't get the damn ball joint free from the adapter!

Adrian@

4,667 posts

313 months

Saturday 9th May 2009
quotequote all
If someone wants to host the pictures email me at, adrian@exactly.demon.co.uk ..I have the upright/adapter and the locking tang that is welded onto the side of the adapter once it is dropped into the upright, as separate items on my office desk, I could draw around the plate and post that off for it to be copied. The tang is the safety locking unit to stop the adapter ever coming out and once in place, and to remove the adapter the weld needs dressing off the lower edge of the tang.
Adrian@

Edited by Adrian@ on Saturday 9th May 18:09