Rocker gear run-in?
Discussion
Hi
What assembly did you end up getting, OE, Aftermarket, Second hand?
What did the new rocker assembly sound like when you started the engine?
If silent (Preload within limits) then I would be tempted to drive it as job done. If there are tapping noises I would go for short drive and recheck.
Phil.
What assembly did you end up getting, OE, Aftermarket, Second hand?
What did the new rocker assembly sound like when you started the engine?
If silent (Preload within limits) then I would be tempted to drive it as job done. If there are tapping noises I would go for short drive and recheck.
Phil.
wrightp said:
Hi
What assembly did you end up getting, OE, Aftermarket, Second hand?
What did the new rocker assembly sound like when you started the engine?
If silent (Preload within limits) then I would be tempted to drive it as job done. If there are tapping noises I would go for short drive and recheck.
Phil.
Got shaft and rockers from RPI in the end. Been told they sell quality stuff. But the shafts did not have a mark indicating installation position, and only two of the rockers were the same as those that came off. All the parts looked ok though. VERY noisy on start up for a short while as i drained the followers down to set the preload. Sounds better now after 30 miles. Have a 350 mile round trip tomorrow on new R888's so will be taking it easy for 100 miles or so anyway.What assembly did you end up getting, OE, Aftermarket, Second hand?
What did the new rocker assembly sound like when you started the engine?
If silent (Preload within limits) then I would be tempted to drive it as job done. If there are tapping noises I would go for short drive and recheck.
Phil.
clive f said:
I`d do a few hundred miles then take off the rocker covers and double check the rocker pads just to be on the safe side, I did exactly the same as you 3 years ago and the rockers only lasted 400 miles!
RPI put it down to a dodgy batch
Going down south this saturday on my family rounds. Can pop over to Isle of Widgit if you about in the morning Clive? YHMRPI put it down to a dodgy batch

Chimjunkie said:
clive f said:
I`d do a few hundred miles then take off the rocker covers and double check the rocker pads just to be on the safe side, I did exactly the same as you 3 years ago and the rockers only lasted 400 miles!
RPI put it down to a dodgy batch
Going down south this saturday on my family rounds. Can pop over to Isle of Widgit if you about in the morning Clive? & you can check the pads for me RPI put it down to a dodgy batch


Seasider said:
Chimjunkie said:
clive f said:
I`d do a few hundred miles then take off the rocker covers and double check the rocker pads just to be on the safe side, I did exactly the same as you 3 years ago and the rockers only lasted 400 miles!
RPI put it down to a dodgy batch
Going down south this saturday on my family rounds. Can pop over to Isle of Widgit if you about in the morning Clive? & you can check the pads for me RPI put it down to a dodgy batch


Only if he insists and replies to my mail!!Del, got the R888's on
1st impressions on cold straight out of the box - WOW!!! The car feels so different and so planted. Oh me likey.Gassing Station | Chimaera | Top of Page | What's New | My Stuff




