cooling system
cooling system
Author
Discussion

bjarkes

Original Poster:

122 posts

215 months

Friday 22nd May 2009
quotequote all
Have just filled my cooling system after fitting a new radiator. After about 7 liters the system was full and coolant started coming out of the bleeding screw. The system is holding 12 liters, is this normal that the about 5 liter still is in the system and didn´t come out when I took the old radiator off?

Bjarke

scotty_d

6,795 posts

225 months

Friday 22nd May 2009
quotequote all
I have drained my system down twice now 1 to do a little repair to the radiator and 2nd to fit silicon hoses and both times it took around 12 Litres to fill. Not sure what is going on with yours seems starnge to hold so much in the block?

BBR

110 posts

230 months

Friday 22nd May 2009
quotequote all
Did you have the heater on hot, run the engine with the expansion tank cap off and top up continually via the swirl pot? I believe thats the method, it worked for me anyway.

scotty_d

6,795 posts

225 months

Friday 22nd May 2009
quotequote all
Bible method is heater full hot keep topping swirl pot till it takes no more (can take a few mins) once it takes no more fit cap tight crack radiator bleed screw and run up let all air out and top up via expansion tank as required then nip bleed screw up when nice flow running out. Don’t be scared to let it run for a while to make sure all air is out then nip up, job done

bjarkes

Original Poster:

122 posts

215 months

Friday 22nd May 2009
quotequote all
Jep read that too. Ran the engine fans kick in fine, and the thermostat open nicely. Let it cool down, and checked the level in the expansion tank all looks fine, so the system must be filled!

Bjarke

bjarkes

Original Poster:

122 posts

215 months

Friday 22nd May 2009
quotequote all
PS: Is it correct understood that if the system needs coolant, it will take what it needs from the expansion tank??

Bjarke