How much oil does your Griff use?
Discussion
jeboa said:
Had mine for 4 years, and average about 3k a year (34k total now).
Uses less than 1/2 litre every 3k, and I am still amazed how clear the oil is when it's dropped.
Started off using Mobil 1, then switched to Silkolene from Opie.
Me too been using Silkolene 10/50 now for a while and uses far less than Mobil 1 plus sounds healthier...and better on cold start upsUses less than 1/2 litre every 3k, and I am still amazed how clear the oil is when it's dropped.
Started off using Mobil 1, then switched to Silkolene from Opie.
culminator said:
just picked up my latest Griff and after a 120 mile drive home, noticed the oil level had dropped. Admitedly, the engine had only done 400 miles since a complete rebuild but looks like its used about 1/4 on the journey home.
Is that acceptable? What do others consume/
Mike
a 1/4 of a litre or a 1/4 of level of the dipstick?Is that acceptable? What do others consume/
Mike
Chris
Hmmmmm, must admit, when i had to top it up, I put a litre of Mobil 1 in it but could only get the 0/40 stuff.
The engine is being run in and I can see blue smoke when i blip the throttle . I've not done more than 30 miles since the top up, so will drain and change the oil to a viscosity that's more appropriate.
Would topping up with a litre of thin oil in a fairly fresh engine create a bit of blue smoke?
Ta muchly
The engine is being run in and I can see blue smoke when i blip the throttle . I've not done more than 30 miles since the top up, so will drain and change the oil to a viscosity that's more appropriate.
Would topping up with a litre of thin oil in a fairly fresh engine create a bit of blue smoke?
Ta muchly
Gassing Station | Griffith | Top of Page | What's New | My Stuff





ked up my memory, so probably 1/2 litre