AJP main bearings
Discussion
Just a note if any of you are rebuilding your engine in the future.
The main bearing shells as someone previously stated are the same as Rover V8, EXCEPT in the AJP they use the only the shells that would normally go into the block ie with the groove down the middle and the oil feed hole. So you will need to get 2 sets and only use half of each! The tang on the caps will not take the Rover V8 cap bearing.
The main bearing shells as someone previously stated are the same as Rover V8, EXCEPT in the AJP they use the only the shells that would normally go into the block ie with the groove down the middle and the oil feed hole. So you will need to get 2 sets and only use half of each! The tang on the caps will not take the Rover V8 cap bearing.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff