Heater stepper motor

[boardinscotland]

PLease Help!!


I bought a new stepper motor and wired it up the correct way(after phoning TVR power a couple of times) however there is still no life. I have tried re wiring it numerous times with no success.
Any one had similar problems.

Cheers

G

Edited by boardinscotland on Friday 17th July 11:42

[lee02]

Mine did the same. It needs to be asembled then un plug and start again. The micro switch on the top sets the distance also the temp sensor on the inlet needs to be heated sometimes. Not easy to explain by email. if you dont get it sorted mail me and i will try to explain properly

lee

[shep1001]

boardinscotland said:

PLease Help!!


I bought a new stepper motor and wired it up the correct way(after phoning TVR power a couple of times) however there is still no life. I have tried re wiring it numerous times with no success.
Any one had similar problems.

Cheers

G

Edited by boardinscotland on Friday 17th July 11:42

Are you sure its the stepper motor? cost me £90 to find out that the motor was OK and it was a dodgy conection on that other bit of the system under the PS dash (amplifier?) that was at fault.

[boardinscotland]

shep1001 said:

boardinscotland said:

PLease Help!!


I bought a new stepper motor and wired it up the correct way(after phoning TVR power a couple of times) however there is still no life. I have tried re wiring it numerous times with no success.
Any one had similar problems.

Cheers

G

Edited by boardinscotland on Friday 17th July 11:42

Are you sure its the stepper motor? cost me £90 to find out that the motor was OK and it was a dodgy conection on that other bit of the system under the PS dash (amplifier?) that was at fault.

Yeah definately the stepper motor. It would open to let cold air in but not shut to let the air go via the small radiator. When I took it out and dismantled the teeth on the plastic cogs had broken off.

Cheers


G

[boardinscotland]

lee02 said:

Mine did the same. It needs to be asembled then un plug and start again. The micro switch on the top sets the distance also the temp sensor on the inlet needs to be heated sometimes. Not easy to explain by email. if you dont get it sorted mail me and i will try to explain properly

lee

Cheers

Will give another shot tomorrow.

G