Any one in Pad Printing?
Any one in Pad Printing?
Author
Discussion

P-J

Original Poster:

1,939 posts

253 months

Monday 24th August 2009
quotequote all
I've been after a football image being put onto a small dome for a new light switch. The couple of printers that I've seen have both said that they couldn't print it onto the dome that I have at the moment, which has resulted in us getting samples made for a new dome (read more expense!) but the sample that we have had made is not what I'm after.
From what I have previously read about pad printing, it is it can be printed onto anything - any shape and any size - is that true? Does it have to be printed onto plastic or will metal be ok too?

Cheers in advance.

P-J

CHIEF

2,270 posts

313 months

Monday 24th August 2009
quotequote all
We have a pad printer at work, if its small its a pieces of p*** we dont do printing but bought it to print ourselves onto aerial sockets etc.


CHIEF

2,270 posts

313 months

Monday 24th August 2009
quotequote all
I dont think it can be printed onto anything to be honest but metal should be fine. our plates are very shiny and hard plastic and it is hard to scratch off as we make sure that the right amount of ink and hardener is used.

We use these people to get our consumables from.
http://printinginternational.co.uk/pi-index.html

maybe ask them if they know of a few printers that can help.



Edited by CHIEF on Monday 24th August 21:22

peterguk M500

2,622 posts

248 months

Monday 24th August 2009
quotequote all
P-J said:
I've been after a football image being put onto a small dome for a new light switch. The couple of printers that I've seen have both said that they couldn't print it onto the dome that I have at the moment, which has resulted in us getting samples made for a new dome (read more expense!) but the sample that we have had made is not what I'm after.
From what I have previously read about pad printing, it is it can be printed onto anything - any shape and any size - is that true? Does it have to be printed onto plastic or will metal be ok too?

Cheers in advance.

P-J
You have PM.

P-J

Original Poster:

1,939 posts

253 months

Monday 24th August 2009
quotequote all
YHM back

Mr POD

5,153 posts

223 months

Monday 24th August 2009
quotequote all
in 1986 - 1987 as an Undergraduate Manufacturing Engineer I was given the job of comissioning a pad printing machine in a Battery Company (Marathon Alcad). In 1994-96 I worked in an automotive switch manufacturing company (Lucas) where the Pad printed logos onto switch mouldings.

In general you can print on most stuff, even cut the pad to clear protusions.