Discussion
Hey guys.. i'v got an audi TT 225 quattro and notice that the rev needle keeps moving up n down while the cars at standstill.. it dosent feel like its going to cut out but does feel theres a problem as its not steady.
im not sure whats the problem, jus wanted to know if any 1 can recomend wat i shud do??
the rev needle is just under 10 and moves between 5-10 what should it be at?
cherz guys any advice would be much appreciated..
im not sure whats the problem, jus wanted to know if any 1 can recomend wat i shud do??
the rev needle is just under 10 and moves between 5-10 what should it be at?
cherz guys any advice would be much appreciated..
Just traded my 225 in at the weekend after 7 years. Mine always did this - did it new, did it after 7 years. Did it after new coil packs, did it after oil change/service etc. Only seemed to move around 250rpm or so but definitely noticeable at a standstill when just switched on. Never caused me any concern or problems.
If I was you I'd just keep an eye on it and if it continues to be a worry get someone to look it over. No point spending £120 on coil packs (add a few quid more if you want them to fit them) if they may not be the problem.....and probably aren't.
If I was you I'd just keep an eye on it and if it continues to be a worry get someone to look it over. No point spending £120 on coil packs (add a few quid more if you want them to fit them) if they may not be the problem.....and probably aren't.
Dr G said:
Colonial said:
You should try mine. Aftermarket Cams and disconnected VVT. The whole car vibrates and shakes at idle now. Bloody awesome.
4,843 posts and you think you'll get off without pictures and specs? Sounds like fun!I've got the stats somewhere. It's getting on the dyno soon for a before and after remap (custom unitronic tune) so I'll do a thread about it. Basically it has Silicon induction hoses, Silicon intercooler hoses, BMC CDA, N75J Race Valve, APR D1 Diverter Valve, 3" custom downpipe to a full remus exhaust, the aforementioned cams, disconnected VVT, suspension (eibach and bilstein) and brakes (slotted rotors and Ferodo DS2500 pads). Once the chip goes on I'm looking at getting a bigger garret turbo and a stealth front mount intercooler.
And not a single external modification.
The cams were interesting - really changed the rev range, much more laggy below 2,200rpm but extending past the previous red line. And it doesn't sound all that subtle anymore

Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


