Stack Display
Author
Discussion

zasker

Original Poster:

581 posts

227 months

Friday 9th October 2009
quotequote all
Just went to go out in the car but when I swithced the ignition on nothing happened on the display. No warning lights, no fuel gauge etc. Car started ok but no rev counter or speedo either. Car is a 2008 Exige S PP. All was working fine about an hour ago and everything else is still working fine. Does the unit have its own fuse, doesn't appear to according to the handbook and all the fuses look ok anyway. Any ideas would be appreciated.

The Bandit

797 posts

218 months

Friday 9th October 2009
quotequote all
I've heard about a few of these failing,looks like a replacement is on the cards(warranty job) frown

Andy G Bmth

5,001 posts

252 months

Friday 9th October 2009
quotequote all
this happened to my 2008 elise apart from I was in the middle of a night run out in the country with the bolocs lot (not fun in the rain!)

mine needed a software update/reflash which took a couple of hours before I could pick it back up.

shouldn't be anything to serious just call the dealer - car is fine to drive just be careful of revs and speed

hth

Andy

Edited by Andy G Bmth on Friday 9th October 18:23

zasker

Original Poster:

581 posts

227 months

Friday 9th October 2009
quotequote all
Thanks for the info. Away all next week so need to get it booked in for the week after, suppose I should try and borrow sat nav so I don't get caught by any Scamera's



LRGS2

143 posts

241 months

Saturday 10th October 2009
quotequote all
Mine did the same on the way to have the dash replaced because of the LCD failing in direct sunlight. It had a sick sense, I drove it to work OK. Then got in it to take it to the garage to be changed and absolutely nothing, no revs or speed or LCD, just the traction control light on. Strange thing is I was going to point this out to the garage and the bloody thing came back on!!