window adjustment

[rens914]

my window on the passenger side isn't closing 100%
there is always a gap of 3 mm (top backside)
it's not a big problem but still annoying when driving on the motorway
anyone adjusted this before ?
rens

[SP6 Animal]

Take the doorcard off you can adjust the runners by loosening the bolts.
Fiddely and time consuming and a pain because you have to keep shutting the door climbing in through other door to adjust because glass drops as you open the door.
You might get away with loosening the glass grab plates adjust and retighten allen bolts.
Lubricate runners aswell.
Done both my doors.

[rens914]

SP6 Animal said:

Take the doorcard off you can adjust the runners by loosening the bolts.
Fiddely and time consuming and a pain because you have to keep shutting the door climbing in through other door to adjust because glass drops as you open the door.
You might get away with loosening the glass grab plates adjust and retighten allen bolts.
Lubricate runners aswell.
Done both my doors.

so
why not do mine
have a bed and a good bottle of wine in return :0)
thankx for the reply
rens

[Basil Brush]

It you just want it to close higher then there is an adjuster screw inside the door for the mechanical stop within the window mechanism.

[SP6 Animal]

Basil Brush said:

It you just want it to close higher then there is an adjuster screw inside the door for the mechanical stop within the window mechanism.

Which worked on the passenger door but nowhere near on my drivers door lol im assuming that's a encoder adjustment which is beyond me.
Both panes shut ok now so suits me tiny gap in top corner can't close that design issue i think.

[Basil Brush]

SP6 Animal said:

Basil Brush said:

It you just want it to close higher then there is an adjuster screw inside the door for the mechanical stop within the window mechanism.

Which worked on the passenger door but nowhere near on my drivers door lol im assuming that's a encoder adjustment which is beyond me.
Both panes shut ok now so suits me tiny gap in top corner can't close that design issue i think.

When I did mine it was just a case of changing the height of the stop and then setting the alarm to set the new fully-closed position. The encoder then counts from there when opening/closing the door.

I only did one door though...