washer nipple problem !!
Discussion
Whilst giving the V8S a shammy after a wash at the weekend I think I may have been a little over vigorous and caught the windscreen washer ‘nipple’ thing. It came clean off, the top snapping off from the bottom piece embedded in the body. It was getting cold & dark and so as a quick fix I have glued it back on, but I don’t think that this will last.
Has anyone else suffered this problem? I could not see an easy way to access the area under the bulkhead to replace the ‘nipple’. Any tips or part numbers to fix this problem.
ade
Has anyone else suffered this problem? I could not see an easy way to access the area under the bulkhead to replace the ‘nipple’. Any tips or part numbers to fix this problem.
ade
The spray bar system works brilliantly. I got mine of a scrap peugoet but they are in expensive new, simply clip on the wiper arm. You need to buy a 'tee' peice to divert the water to the two spray bars (motor factor) and buy some tube. Loads of cars use them, including my Vito van!
I think you can access the pipe from underneath with some buggeration, idealy fish it through the existing hole, try wire or turning a screw into the broken end if you can get to it.
Good luck!
I think you can access the pipe from underneath with some buggeration, idealy fish it through the existing hole, try wire or turning a screw into the broken end if you can get to it.
Good luck!
Gassing Station | S Series | Top of Page | What's New | My Stuff




