petrol Seepage Fuel Sender
petrol Seepage Fuel Sender
Author
Discussion

Gerald-TVR

Original Poster:

4,896 posts

226 months

Sunday 17th January 2010
quotequote all
Suggestions please as how to ensure no seepage, just topped up tank and there is some petrol seepage around the sender unit. It has new locking ring and seal, what sealant do you suggest please

Elfit

573 posts

233 months

Sunday 17th January 2010
quotequote all
Hi Norm
The seals should be good enough on their own.
From memory the Landrover ones (ARA 1502) are a bit thicker than the originals
If the lugs on the tank are bent out they can be lightly tapped back in for a tighter fit.

Can't suggest a sealant I'm afraid. I know NOT to use silicone as it will evenyually dissolve.

Cheers
Tim




tvrgit

8,489 posts

281 months

Sunday 17th January 2010
quotequote all
I'm with elfit on this one - it took me countless goes of bending the little tags on the tank, and refitting the ring, but I was determined not to use sealant because (a) there are only a few that are resistant to petrol (b) I didn't want to risk sealer squeezing out inside the tank and blocking something up and (c) the sealer might be a right bd to remove if you ever need to get the sender out again!

I have also read that the land rover seal is slightly thicker but I think I just used a standard one - can't remember now.


Wiz

2,474 posts

243 months

Sunday 17th January 2010
quotequote all
Noticed my tank seeping last year, got a new seal but the tank was full for the winter lay up.
Decided to do it this winter. Guess what! filled the tank up again banghead, needs a new hose as well.
Another job for Spring.

mep12345

2,061 posts

230 months

Sunday 17th January 2010
quotequote all
I had same problem Norm and looked for ages for a sealant then went to Halfrauds and got a tube of Hermetite Red as a last resort, which is "resistant" to petrol. If you smear this on the inside of the recess then on both sides of the rubber seal it makes installation of the seal and locking ring easier as it slips round on the sealant and then the sealant goes semi-hard after about 30 mins and stays that way for good. As it only semi-sets disassembly and re-assembly is easy afterwards - I just clean off old stuff and re-apply (have had to do the job 3 times to date after first use of Hermetite - but not for leaks).

Tank has never weaped after using the Hermetite, make sure it is the Red variety as the othrs (blue and green) are not petrol resistant.

HTH

Mark