Alarm Sensitivity
Alarm Sensitivity
Author
Discussion

SP6 Animal

Original Poster:

6,015 posts

239 months

Saturday 27th February 2010
quotequote all
Another job i need to do is adjust the alarm as it goes off too easily.
On my chim it was under the tunnel i can't find it there on the Tuscan can any one tell me please where it is.
Thanks

PetrolHeadPete

791 posts

218 months

Saturday 27th February 2010
quotequote all
In behind the ash tray tube thing under the tunnel cover. In with the two door controller modules.

SP6 Animal

Original Poster:

6,015 posts

239 months

Saturday 27th February 2010
quotequote all
Thanks pete for a moment i thought you was going to get you're own back.biggrin
Can't remove tunnel completely as screw at the back under vent just spins i wonder if there's a nut underneath.
Did manage to get my fingers underneath around handbrake but just felt the air pipe so gave up looking in that arearolleyes

PetrolHeadPete

791 posts

218 months

Saturday 27th February 2010
quotequote all
It's a self tap so try pulling it out

SP6 Animal

Original Poster:

6,015 posts

239 months

Sunday 28th February 2010
quotequote all
Thanks pete spot on screw thread was wrapped in carpet thread now fitted new screw after ripping it outbiggrin
Sensitivity was set to half now at a third that screw slot is small.

PetrolHeadPete

791 posts

218 months

Sunday 28th February 2010
quotequote all
Good stuff.
Must do mine somewhen...it has a tendency to go off in the work car park in the summer with the roof left off if someone parks next to it. Most annoying wink

shep1001

4,620 posts

218 months

Sunday 28th February 2010
quotequote all
SP6 Animal said:
Thanks pete spot on screw thread was wrapped in carpet thread now fitted new screw after ripping it outbiggrin
Sensitivity was set to half now at a third that screw slot is small.
Sensitivity (field of vision) of the microwave sensor will vary dependant on ambient temp. They are a PITA to set up. The cover should pop off the box to make adjusting the pot easier.

Shep

Curdster

484 posts

213 months

Monday 1st March 2010
quotequote all
Shep can you quantify "field of vision". Is it an "eye" and if so where is it? I was under the impression it was a motion sensor. Can you PM me as I am driving the neighbours mad and I think the fitted cover I use may be causing movement in the wind/rain etc.

shep1001

4,620 posts

218 months

Monday 1st March 2010
quotequote all
Curdster said:
Shep can you quantify "field of vision". Is it an "eye" and if so where is it? I was under the impression it was a motion sensor. Can you PM me as I am driving the neighbours mad and I think the fitted cover I use may be causing movement in the wind/rain etc.
YHM. More to do with its placement I suspect as well as how sensitive its set....