Honda CRV overheating at 70+mph
Honda CRV overheating at 70+mph
Author
Discussion

frosted

Original Poster:

3,549 posts

208 months

Monday 1st March 2010
quotequote all
Just want to pick your brains for something , earlier I was driving with my friend in her auto 95' Honda CRV, reached m25 and after 20 minutes it started overheating at 70-90 mph . We slowed down to 60 and we could see the needle going back down to near normal, stopped at the services and I noticed she had a small leak on the drivers side of the radiator . The coolant seemed full , with no milky stuff in the engine.

After a 5 minute stop we got going and drove for 40-50 miles + London traffic with no problems ( albeit at 60mph )

Anyone know what could be happening ? She doesnt want to drive the car no more and I dont think she has money for another or to fix the headgasket

Any help would be appreciated

I guess could ask for some pics later

TheEnd

15,370 posts

219 months

Monday 1st March 2010
quotequote all
low coolant will do that, not enough of it to shift the large amounts of heat generated.
i've seen similar symptoms on a transit, only at high speeds will it creep up, anything else is fine.
the heaters also sometimes run cold this way. It might not be your exact problem, but it's one possible cause

frosted

Original Poster:

3,549 posts

208 months

Monday 1st March 2010
quotequote all
I did fill the radiator with some water from those air machines , it was full within 3 seconds, which lets me to believe it was full already

TheEnd

15,370 posts

219 months

Monday 1st March 2010
quotequote all
it could be airlocked, and only seem full.
remember, if it was leaking, it'd have to go down.

the hole on the rad could also stop it from pressurising properly, which can make them boil over.

frosted

Original Poster:

3,549 posts

208 months

Monday 1st March 2010
quotequote all
I see , if it was the headgasket would it overheat at idle and low speeds ? Think thats my main concern

TheEnd

15,370 posts

219 months

Tuesday 2nd March 2010
quotequote all
if it was the HG, it'd either mix oil into the water, or blow exhaust gasses into the coolant system, (or sometimes both - oil in water isn't the only test, but can be present)

the correct way to test is with a pH test that will check to see if gasses are disolving into the coolant (it'll turn slightly acidic) or hang an exhaust probe over the filler to check to CO, but you can often just sniff it yourself and see if it has the stale air smell or sweet coolent smell, which is normal, or the smell of fumes and exhaust which is bad.
leaking coolant also has another smell, which is kinda spicy/curry like. strange but true...

so it should smell like a takeaway from outside (from the rad leak) and stale at the tank, which is OK, or like fumes at the tank which is bad.

a failing waterpump or blocked rad could also cause similar problems, dropping the efficiency of the system, so it can't cope under high demand

frosted

Original Poster:

3,549 posts

208 months

Tuesday 2nd March 2010
quotequote all
TheEnd said:
if it was the HG, it'd either mix oil into the water, or blow exhaust gasses into the coolant system, (or sometimes both - oil in water isn't the only test, but can be present)

the correct way to test is with a pH test that will check to see if gasses are disolving into the coolant (it'll turn slightly acidic) or hang an exhaust probe over the filler to check to CO, but you can often just sniff it yourself and see if it has the stale air smell or sweet coolent smell, which is normal, or the smell of fumes and exhaust which is bad.
leaking coolant also has another smell, which is kinda spicy/curry like. strange but true...

so it should smell like a takeaway from outside (from the rad leak) and stale at the tank, which is OK, or like fumes at the tank which is bad.

a failing waterpump or blocked rad could also cause similar problems, dropping the efficiency of the system, so it can't cope under high demand
Thank you , guess ill have to tell her to take it to a mechanic

frosted

Original Poster:

3,549 posts

208 months

Friday 12th March 2010
quotequote all
well it seems the hgf is gone.

Spoke to a friend of a friend who is mechanic and he says he can change the headgasket for 650 . Now this is not too bad but he is also saying that he had a chat with Honda and they belive that if the hgf is gone there would be alot more damage done to the engine .

Anyone know what this is likely to be ?

He wants to put kseal in the rad instead of fixing the engine , is this a really bad idea ??

tkdsteve08

235 posts

207 months

Friday 12th March 2010
quotequote all
I Work for Honda

The Head gasket is very common on the crv's and we sell loads of them

Sorry

frosted

Original Poster:

3,549 posts

208 months

Friday 12th March 2010
quotequote all
thanks for the info , just wanted to know the possibilty of cylinder problems after i skim the head