Interior light
Interior light
Author
Discussion

Murph7355

Original Poster:

41,969 posts

285 months

Sunday 7th March 2010
quotequote all
First couple of daft questions coming up...

The interior light doesn't operate with the doors opening. Can turn it on permanently (two of the three switch positions) or off (the third position). But not with it coming on with the doors.

Any ideas?

Battery doesn't appear to drain excessively so am doubtful it's the relay?

And the alarm turns on OK - assuming it uses the same door switches?

Not exactly a major issue. Thought I'd ask (wait until you see question 2).

BliarOut

72,863 posts

268 months

Sunday 7th March 2010
quotequote all
First question has to be does that go for both interior lights?

spend

12,581 posts

280 months

Sunday 7th March 2010
quotequote all
From memory, middle position is off, then one way is always on and the other is timer controlled. If none work check the bulb first.

..but lots off Griff owners pull the relay to stop the whole lot working (heated mirror defeat as well hehe).

ETA: a hazy memory makes me think Mikes car maybe doesn't have the footwell light? Could be wrong but I think we spoke about it being on the AJPGriff?

Edited by spend on Sunday 7th March 22:49

Murph7355

Original Poster:

41,969 posts

285 months

Sunday 7th March 2010
quotequote all
Haven't looked at/for the footwell light yet.

Middle position is off. The other two have the light permanently on.

spend

12,581 posts

280 months

Sunday 7th March 2010
quotequote all
Leave the doors closed for 5mins, then reach in & switch each way, if both come on, either your door switch or timer relay are faulty wink

ray_von

3,039 posts

281 months

Monday 8th March 2010
quotequote all
spend said:
ETA: a hazy memory makes me think Mikes car maybe doesn't have the footwell light? Could be wrong but I think we spoke about it being on the AJPGriff?
It does
spend said:
or timer relay are faulty wink
OOH OOH I might have finally got an electrickery question right biggrin
probably not though hehe

Murph7355

Original Poster:

41,969 posts

285 months

Monday 8th March 2010
quotequote all
ray_von said:
...
OOH OOH I might have finally got an electrickery question right biggrin...
Just to let you know you're not the only one, the "fault" was me being a tit biggrin

The word "timer" should have been enough - wasn't leaving it long enough before assuming the light was faulty and opening the door again.

All working as it should.

Chimpaholic

9,637 posts

208 months

Tuesday 9th March 2010
quotequote all
Hi all,

My Chimaera has a similar fault, or is it a fault?

I had no idea about the timer.

Does my Chimaera have such a delay timer relay too?

I replaced the door switches recently as they were definitely faulty, but the interior light still stays on with the switch in the door operation position & after the door has been closed.

I must admit I have not waited to see if it goes out after a delay, how long is the delay.

Thanks in advance.

BliarOut

72,863 posts

268 months

Tuesday 9th March 2010
quotequote all
How long? Just long enough to make you think it's not going to go out hehe Locking the car should turn them off pretty much straight away.

Chimpaholic

9,637 posts

208 months

Tuesday 9th March 2010
quotequote all
Thanks I will do some experimentation.


spend

12,581 posts

280 months

Tuesday 9th March 2010
quotequote all
Could be a long delay in this climate, work fine in the summer (when yikes)

Murph7355

Original Poster:

41,969 posts

285 months

Tuesday 9th March 2010
quotequote all
Mine stays on for 1-2mins. I think the switch needs to be towards the front of the car (middle position is off, rear position is on permanently).

spend

12,581 posts

280 months

Tuesday 9th March 2010
quotequote all
Murph7355 said:
Mine stays on for 1-2mins. I think the switch needs to be towards the front of the car (middle position is off, rear position is on permanently).
It depends on which way round you fitted the lights + which way you connected the terminals (their just single spades) hehe

Murph7355

Original Poster:

41,969 posts

285 months

Saturday 13th March 2010
quotequote all
While I'm on a roll with simple problems made to look hard, does the interior light under the glovebox run on the same circuit as the one in the hood roll?

Can't make that one work and was wondering if it runs from a separate fuse.

spend

12,581 posts

280 months

Saturday 13th March 2010
quotequote all
Same circuit, checked the bulb and contacts inside the holder?

Murph7355

Original Poster:

41,969 posts

285 months

Saturday 13th March 2010
quotequote all
spend said:
Same circuit, checked the bulb and contacts inside the holder?
Thanks spend.

Changed the bulb for a new one and the contacts look OK. Think I'll go and swap the lights over to see if it's a fault with the light unit itself and will take it from there. At least I know it's not the fuse now smile

spend

12,581 posts

280 months

Saturday 13th March 2010
quotequote all
Do check that the holder is wired up the right way. IIR its a constant ground with the switching between constant 12v and the timed 12v.. but they are just 3 spades that are easy to shuffle around hehe