Decent blow torch....???
Decent blow torch....???
Author
Discussion

Fastra

Original Poster:

4,289 posts

240 months

Sunday 14th March 2010
quotequote all
I need to remove a lamda sensor from a new exhaust manifold I've just bought from a scrap yard and need to get some heat into it as it just won't budge.
So do you reckon something like this would help or do I need to be thinking bigger???


Halfords: GoSystem DIY Blow Torch £9.99




http://www.halfords.com/webapp/wcs/stores/servlet
/product_storeId_10001_catalogId_10151_productId_218114_langId_-1_categoryId_165727

skyslimit

524 posts

203 months

Sunday 14th March 2010
quotequote all
I did a lower balljoint on a rover 600 the other day, and a blowtorch similar to that one just didn't do it, it couldn't put the sort of heat in I needed.

It needed a serious dose of oxy acetalene go get it out of there.

Fastra

Original Poster:

4,289 posts

240 months

Monday 15th March 2010
quotequote all
Thanks!

Just been reading a couple of plumbing forums and a few people mention this, and in particular its effectiveness in freeing off rusted nuts:

Rothenberger Super Fire 2

http://cgi.ebay.co.uk/Rothenberger-2-Pc-Kit-SuperF...



snotrag

15,754 posts

242 months

Monday 15th March 2010
quotequote all
Having recently changed a Lambda sensor on a 16yr old car - the spanner/socket makes more of a difference than the blowtorch.

You can buy specific sockets for removing lambda probes - its a deep, 6 sided, wall drive socket, with a slot all along one side to allwow you to slip it over. 1/2" drive. worked a treat. Think theres only two std sizes of probe too, mine was 23mm IIRC?

I'd been fannying around for ages with normal sockets and spanners, but that, with a touch of heat and a 2 ft bar came off easy peasy.

Fastra

Original Poster:

4,289 posts

240 months

Monday 15th March 2010
quotequote all
snotrag said:
Having recently changed a Lambda sensor on a 16yr old car - the spanner/socket makes more of a difference than the blowtorch.

You can buy specific sockets for removing lambda probes - its a deep, 6 sided, wall drive socket, with a slot all along one side to allwow you to slip it over. 1/2" drive. worked a treat. Think theres only two std sizes of probe too, mine was 23mm IIRC?

I'd been fannying around for ages with normal sockets and spanners, but that, with a touch of heat and a 2 ft bar came off easy peasy.
biggrin

Cheers - just bought the very thing, not 10 minutes ago!



http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...