Vauxhall Frontera won't start
Discussion
A neighbour has a petrol version of one of these. The engine is turning ok but it won't fire into life. Every so often I can hear a slight cough, but nothing more.
Battery has been fully charged twice (I know because he keeps borrowing my charger
), I gave everything electronics-wise a quick waggle in the engine bay but otherwise I know little or nothing about what could be causing it. IIRC its a 4-cylinder engine, electronic ignition. I'm sure I can smell fuel coming through, but only because he has been pumping the accelerator while turning the engine (I asked him not to do that). My hunch is that there isn't a spark, but access to the plugs is difficult, I don't know him that well, and I'm not about to start pulling his engine to bits.
Anyone heard of anything similar? I've asked him to get the codes read, but other than that I'd just be guessing.
Battery has been fully charged twice (I know because he keeps borrowing my charger
), I gave everything electronics-wise a quick waggle in the engine bay but otherwise I know little or nothing about what could be causing it. IIRC its a 4-cylinder engine, electronic ignition. I'm sure I can smell fuel coming through, but only because he has been pumping the accelerator while turning the engine (I asked him not to do that). My hunch is that there isn't a spark, but access to the plugs is difficult, I don't know him that well, and I'm not about to start pulling his engine to bits.Anyone heard of anything similar? I've asked him to get the codes read, but other than that I'd just be guessing.
Just got rid of my girlfriends old Frontera (L reg). Had a few problems with getting it started, which sounds similar to yours. One problem led to another one starting.
The Fuel relay switch (I think) was a bit dodgy, and needed to be fiddled around with to get the car to start, if it wouldn't after a few attempts, the engine seemed to really easily flood. Took the dizzy off and emptied it out and it started first go.
The Fuel relay switch (I think) was a bit dodgy, and needed to be fiddled around with to get the car to start, if it wouldn't after a few attempts, the engine seemed to really easily flood. Took the dizzy off and emptied it out and it started first go.
Parrot of Doom said:
I haven't seen a distributor on this one, anyone know where it is (if there is one)?
I think it's right at the back of the engine...It's a b!tch to get at, but sometimes you just have to get your hands dirty

I would run the engine over a few times with the fuel pump fuse pulled as well, to clear any excess fuel from the cylinders
jbi said:
Parrot of Doom said:
I haven't seen a distributor on this one, anyone know where it is (if there is one)?
I think it's right at the back of the engine...It's a b!tch to get at, but sometimes you just have to get your hands dirty

I would run the engine over a few times with the fuel pump fuse pulled as well, to clear any excess fuel from the cylinders
Ok when he returns the charger I'll ask him about these things, and see if I can find the dizzy. Sounds reasonable to me, I repaired a mate's car once whose dizzy was full of water, and whose leads were like a 30-year-old carpet base 
I'll pull the fuel pump fuse also and give it 30 seconds of cranking to clear it out.
My concern is that he told me that a mate of his suggested it might be the head gasket. I think his mate is guessing, and its expensive guessing. He hasn't even had the codes read yet.

I'll pull the fuel pump fuse also and give it 30 seconds of cranking to clear it out.
My concern is that he told me that a mate of his suggested it might be the head gasket. I think his mate is guessing, and its expensive guessing. He hasn't even had the codes read yet.
Bloody hell you weren't kidding about that dizzy. Its impossible to get to, so I didn't try.
His neighbour can get a code reader and has ventured the opinion that the CPS has gone, as the ECU light on the dash stays lit before cranking (it should, apparently, go out). I thought that CP sensors usually caused the engine to fail when hot...
His neighbour can get a code reader and has ventured the opinion that the CPS has gone, as the ECU light on the dash stays lit before cranking (it should, apparently, go out). I thought that CP sensors usually caused the engine to fail when hot...
Its not a dizzy as such,the cap is bolted direct to the end of the cylinderhead cam carrier, and the rotor arm inside runs directly off the camshaft end. Pull the king lead out and earth it to the engine to see if the coil is generating some sparks,if itis then the cap center electrode has prob failed ,was a common fault on those set ups asi recall.
Gassing Station | General Gassing [Archive] | Top of Page | What's New | My Stuff



