How easy are radiators to repair?
How easy are radiators to repair?
Author
Discussion

AJI

Original Poster:

5,180 posts

248 months

Friday 19th March 2010
quotequote all
How easy would an aluminium radiator be to repair if it had a pin hole crack in it somewhere in the core that only lets steam out when the engine is hot and the water system is up to pressure?


Are such small holes an easy repair on an aluminium core, or would such a repair only be temporary and not withstand any track driving for example?


Cheers for any help.



anonymous-user

85 months

Friday 19th March 2010
quotequote all
One of my old cars has this very problem, i stuck some of that radiator st in the header tank, never leaked & was still going strong years later.

Orb the Impaler

1,881 posts

221 months

Friday 19th March 2010
quotequote all
Not sure how this goes with an ally radiator, but in the past whenever I have needed a new one I've simply had them re-cored. Used to be about 80 quid for a big one (Toyota Landcruiser 4.0, 406 Coupe 3.0 for example). Takes a few hours. Effectively you get a new rad. Look up 'radiator repairs' or look for your local 'Serck-Marston' emporium.

mat205125

17,790 posts

244 months

Friday 19th March 2010
quotequote all
If the leak is accessible enough to be able to clean the surface and patch with a bit of TIG then it'll be fine, however the leaking core may be compromised.

Remove the item, and find yourself a local specialist welder.

stoocake

330 posts

203 months

Friday 19th March 2010
quotequote all
I used a blob on JB Weld on mine when it had a reasonably large stone chip on it...held up for 2 years on my track car, so if it's done properly it should definately last!