Installing a 'new' engine....???
Installing a 'new' engine....???
Author
Discussion

Fastra

Original Poster:

4,289 posts

240 months

Friday 19th March 2010
quotequote all
My Astra's appetite for oil is worsening, the smoke clouds behind me are getting worse, and I can only put so much Stop Smoke in.

The economics of getting a new car are beyond me at the moment so I'm now faced with the prospect of sourcing a replacement engine (a rebuild would be too costly), and I pick up a low'ish mileage unit for about £400.

But what preparation should be done to it whilst its on the floor?
Cambelt, waterpump and clutch????

jains15

1,013 posts

204 months

Friday 19th March 2010
quotequote all
Anything that's cheaper or easier to do with the engine out of the car. So all of the above, possibly belts and idlers as well. Cambelt would need to come off if you're doing the waterpump so that's a replace. While there is no engine in the car it would be a good time to check the radiator too. Make sure you're putting a working unit in the car though, no point spend money on a clutch if the engine don't run!!!


Pigeon

18,535 posts

277 months

Saturday 20th March 2010
quotequote all
Fastra said:
The economics of getting a new car are beyond me at the moment so I'm now faced with the prospect of sourcing a replacement engine (a rebuild would be too costly), and I pick up a low'ish mileage unit for about £400.
You can probably get a whole car which will be comparable with an Astra old enough to have a fked engine for £400.