Fords 1.4TDCI lump - are they bulletproof?
Fords 1.4TDCI lump - are they bulletproof?
Author
Discussion

qooqiiu

Original Poster:

753 posts

228 months

Wednesday 24th March 2010
quotequote all
As per title.

Any potential problems i should know about?


Thank you very much.

HellDiver

5,708 posts

213 months

Wednesday 24th March 2010
quotequote all
qooqiiu said:
Any potential problems i should know about?
They're made by Peugeot.

patmahe

5,924 posts

235 months

Wednesday 24th March 2010
quotequote all
HellDiver said:
qooqiiu said:
Any potential problems i should know about?
They're made by Peugeot.
Who apparently make very good diesel engines, never had one myself though.

UncappedTag

2,102 posts

216 months

Wednesday 24th March 2010
quotequote all
PSA engine, also use in Citroen, Ford & Mini

http://en.wikipedia.org/wiki/PSA_HDi_engine

LeightonBuzzard

463 posts

209 months

Wednesday 24th March 2010
quotequote all
i had to replace the injector washers from a 56 plate low mileage one, nightmare job takes a while, rocker cover off and load of other crap above that.

Made in FRANCe beware

WildCards

4,061 posts

248 months

Wednesday 24th March 2010
quotequote all
I doubt it, it would weigh too much i'd have thought.

UncappedTag

2,102 posts

216 months

Wednesday 24th March 2010
quotequote all
LeightonBuzzard said:
i had to replace the injector washers from a 56 plate low mileage one, nightmare job takes a while, rocker cover off and load of other crap above that.

Made in FRANCe beware
And the UK & India.

Edited by UncappedTag on Wednesday 24th March 16:06

qooqiiu

Original Poster:

753 posts

228 months

Wednesday 24th March 2010
quotequote all
I thought those engines were made in good ol ESSEX???

qooqiiu

Original Poster:

753 posts

228 months

Wednesday 24th March 2010
quotequote all
Has anyone Bluefined there 1.4TDCI? If so how much better is your economy?

Billywink

18 posts

200 months

Friday 26th March 2010
quotequote all
speaking from experience, my Festa 1.4D currently has a small and annoying leaking water pump and a small and annoying leaking fuel pump, which will no doubt run into the several hundreds of pounds to sort out , unless I can be arsed to do it myself. Oh, and the exhaust gas recirc has a leak somewhere too, which means exhaust fumes being drawn into the cabin in stationary traffic unless I put the vent into full recirc.

As you can imagine, I really wish I hadn't.

Edited by Billywink on Friday 26th March 22:59


Edited by Billywink on Friday 26th March 23:10

Rollcage

11,345 posts

223 months

Friday 26th March 2010
quotequote all
LeightonBuzzard said:
i had to replace the injector washers from a 56 plate low mileage one, nightmare job takes a while, rocker cover off and load of other crap above that.

Made in FRANCe beware
I can agree with this - all a single piece of plastic that looks pretty hideous!

roscozs

477 posts

212 months

Friday 26th March 2010
quotequote all
I hate the engine. The early ones are prone to Injector Seals leaking. I belive this was due to Ford using thier own injectors instead of the PSA ones. However Im not sure if this is right. But the fact is the seals can fail.

Rocker covers also leak as do the sumps.

Leak off pipe diesel leaks are common also.

They are prone to coolant leaks from the rear of the engine due to rigid coolant pipes splitting.

Ive fitted a few turbos to them too due to failed seals and also EGR Coolers.

I think its in my experience the most hatefull engine Ford put in thier cars. I havent come across any problems with the 1.4 TDCI engine fitted to the New Fiesta however.



Edited by roscozs on Friday 26th March 23:12

redtwin

7,518 posts

213 months

Saturday 27th March 2010
quotequote all
Wife has an '03 Fiesta with this engine. Only engine issue in 81K miles has been a leaky thermostat housing.

tom0507

37 posts

257 months

Saturday 27th March 2010
quotequote all
My '03 Fiestas done 113k miles, never had a problem with it so far.....*fingers crossed*