Duratec V6 Engine block drawing

[Joe T]

I am looking for a drawing of the rear part (end on view) of a V6 Duratec Engine showing the bellhousing bolts and flywheel bolts PCD.
I need it to compare it to another engine and its been pointed out the is engine is installed in some of the Nobles

Thanks

[ThatPhilBrettGuy]

I've got one somewhere I think. I'll dig it out tomorrow and post it.

[Joe T]

Thanks, I will mail you so you have my address.

[AMG Merc]

That's nice looking motor there Joe. Like the striping effect too.

[Joe T]

Thanks, my fibreglass guy decided to do a stripe in the gelcoat, looks ok from a distance, we did it as we had a show coming up and needed to stand out a bit.

Edited by Joe T on Thursday 15th April 09:31

[andygtt]

Hiya Joe, long time no speak... what the duratec going in?

[Joe T]

Hi Andy

Well I am back on the T70, I am seriously considering squeezing an Aston V12 in the back, a sort of modern take on the Lola Aston.

Not much Tech info about on V12, I need to get an adapter for the G50 sorted so trying to get a drawing for the rear bolt pattern, as well as flywheel PCD, would be good if I could get a section through the crank as well, as the flywheel will be interesting to sort out.
The Aston Engine was designed by Cosworth under the control of Ford, shares a few bits with the Duratec.

Hows your project going.

Good to hear from you

[CNHSS1]

any chance you can send me a copy of the bellhousing pattern too please

cheers
CNH

[Joe T]

If and when I find anything I will send you a copy.

[ThatPhilBrettGuy]

Joe T said:

If and when I find anything I will send you a copy.

I haven't forgotten

[Joe T]

I am still on the lookout for this if anyone can help

[ThatPhilBrettGuy]

YHM