effilive /ringram
Author
Discussion

nitrosman1

Original Poster:

641 posts

226 months

Tuesday 20th April 2010
quotequote all
does anyone know if there is the facility in effilive on a ls2 2005 ro to change the settings or switch off the low temp/ revs warning light on the dash as i have a 190 degree state now so the car is running a bit cooler and it never gets hot enough to cancel the warning light

doleboy

747 posts

248 months

Tuesday 20th April 2010
quotequote all
If Rich doesn't get back to you, you could always download an eval copy of the software and see what the PIDs will do.

If it sucks you in deeper, I'm sure he won't mind

ringram

14,702 posts

279 months

Tuesday 20th April 2010
quotequote all
It should still turn off. Do you mean when RPM is high and engine is cold?
What warning light? Are you sure you arnt throwing a code?

Take a look here http://www.holdencrazy.com/EFILive/stockTunes.php
You can download a 2005 HSV tune and take a look at it. Just download the software from efilive.com

You will see various settings under "Engine Protection" etc. You can alter the trigger points etc. But Im not 100% sure what warning light you are getting.

nitrosman1

Original Poster:

641 posts

226 months

Tuesday 20th April 2010
quotequote all
its the red light that flashes up and you get an audible alarm when the engine is cold and the revs are up at around 4500 not an engine check light
because im running a 190 degree thermostat it doesnt quite get hot enough to dissengage the warning so hoping to ask a favour of someone to make an ajustment just wanted to know if is possible on my car with effi as rogers software doesnt allow to change this setting

behold81

2,931 posts

200 months

Tuesday 20th April 2010
quotequote all
Just looked on an LS1 tune and there are 2 options.

Cold Engine Protection Timer (SECS)
Cold Engine RPM Limiter (RPM)

Also there is

Engine Protection Alarm (oC) Set at 140

So from looks of it YES....

ringram

14,702 posts

279 months

Tuesday 20th April 2010
quotequote all
Hmm, maybe. It could be that you have to approach it by increasing or removing the cold engine rpm level.
So just tell it never to warn about cold engine over rev conditions for example. (ie) Blank out the whole table. (Or just reduce it somewhat)
Ive loaned my unit out, but hope to get it back soon.. We can certainly take a look at it at that point.

nitrosman1

Original Poster:

641 posts

226 months

Tuesday 20th April 2010
quotequote all
behold81 said:
Just looked on an LS1 tune and there are 2 options.

Cold Engine Protection Timer (SECS)
Cold Engine RPM Limiter (RPM)

Also there is

Engine Protection Alarm (oC) Set at 140

So from looks of it YES....

needs to be ls2 as aparently there is a difference between them
but looked at an ls2 2005 clubsport looks like theres ajustment under C.A.G.S thanks ringram

ringram

14,702 posts

279 months

Tuesday 20th April 2010
quotequote all
..more likely Engine Protection.. but yeah, there are a few likely suspects in there.