Wideband installations and info
Wideband installations and info
Author
Discussion

behold81

Original Poster:

2,931 posts

200 months

Friday 23rd April 2010
quotequote all
What is the prefered way to instal?? is it prefered to replace an existing O2 sensor or tap a new hole?

Do you all leave it in place?

Any tips will be useful.

Thanks

ringram

14,702 posts

279 months

Friday 23rd April 2010
quotequote all
Depending on car I feed them up past the trans shifter into the footwell.
Personally I go open loop and therefore can use the stock sensor location while tuning.
But if you want to monitor stock operation you will need a new hole, preferably pre cat.

MadMaxHSV

1,816 posts

229 months

Friday 23rd April 2010
quotequote all
If it's not a lot of extra trouble for you, put a new bung in. So you save the trouble of changing the sensors over if you want to switch between open/closed loop.

stigmundfreud

22,454 posts

241 months

Friday 23rd April 2010
quotequote all
def get a bung, you can then return to closed loop and retain logging. I wouldnt personally trust the wb to do both wb and nb despite the fact it should be easy. I ran my LC's up via the empty bung in the drivers side of the footwell/transmission tunnel but would if doing again route via engine bay and firewall.

Consider the PLX as the LC's i've had were nothing but trouble and repeated comments elsewhere to the same effect.

Getting PLX installed this time

MyM8V8

9,468 posts

226 months

Friday 23rd April 2010
quotequote all
If you weld a bung in, make sure its straight out at 3 or 9 o'clock or preferably at and angle upwards from that. Never install them at a downward angle.

I haven't, but I would advise taking them out between tuning as the working life is reduced. I've just taken delivery of a new sensor after only 3k miles.

ringram

14,702 posts

279 months

Friday 23rd April 2010
quotequote all
Some abuse for PLX on ls1.com.au as well. http://www.ls1.com.au/forum/showpost.php?p=1496001...
Ive not had too much trouble with the LC1's but I just fit and forget.
One did go awol on me, so replaced sensor. First in about 3 years.

I understand the sensors are consumables.

Not to say there isnt better brands around smile

stigmundfreud

22,454 posts

241 months

Friday 23rd April 2010
quotequote all
ringram said:
Some abuse for PLX on ls1.com.au as well. www.ls1.com.au/forum/showpost.php?p=1496001&postcount=7
Ive not had too much trouble with the LC1's but I just fit and forget.
One did go awol on me, so replaced sensor. First in about 3 years.

I understand the sensors are consumables.

Not to say there isnt better brands around


cant see that link at work but am I guessing its the slow switching thread (probably from 2006/7) ?