Cleaning the throttle body FAO crisisjez
Cleaning the throttle body FAO crisisjez
Author
Discussion

AndiD

Original Poster:

147 posts

198 months

Sunday 16th May 2010
quotequote all
Hi mate (or anyone else reading who can give some advice)

You mentioned before how when your Ro was cutting out it just needed the throttle body cleaning.. By process of elimination I reckon I might need to do the same. Can you give me some idiot instructions on how to do this, as I don't know my way around this engine yet and would appreciate any help!

Thanks v v much in advance

Andi

doleboy

747 posts

248 months

Sunday 16th May 2010
quotequote all
Think Jez said he cleaned the Throttle Position Sensor rather than the throttle body itself.

ringram

14,702 posts

279 months

Sunday 16th May 2010
quotequote all
Yeah I helped someone out with a dodgy TB, they had some DTC codes pointing at the ETC we checked the connection and it was loose.
They dont clip on very firmly.

Earlier throttles with IAC may need cleaning in there too due to PCV oil gumming them up.
Really depends what your problem is...

crisisjez

9,209 posts

236 months

Sunday 16th May 2010
quotequote all
Bit of brake cleaner and a cotton bud or 2 then some vaseline or similar as a contact lubricant...job done

AndiD

Original Poster:

147 posts

198 months

Sunday 16th May 2010
quotequote all
I'm going to sound like a nob now, but how do you pull the sensor out? There's that little grey clip on the side that slides forward but there doesn't seem to be any movement and I don't want to force it..?

crisisjez

9,209 posts

236 months

Sunday 16th May 2010
quotequote all
I;m talking about the 8 pin throttle body to wiring harness connector.