vw 1.8 turbo engine aum
Discussion
Hi all im new to the site so a big hello :-),ive a problem with my 1.8 turbo golf, my dad has been using it and has blown the engine up through lack of servicing !... the engine code is AUM can i replace the engine with a diffrent coded engine as im having problems sourcing AUM engine,and the cost of a rebuild in not worth doing on the car due to its value ?
cheers
All help would be greatly recieved
cheers
Andy
cheers
All help would be greatly recieved
cheers
Andy
Oil pumps can sludge up on these engines if regular oil changes aren't done, so maybe this was the cause.
Sign up to www.edition38.com/forums there are normally a few 1.8T engines for sale.
AUM is drive by wire throttle so you'll be needing an AUM / AUQ. Not sure if ealier engines can be converted to DBW?
Sign up to www.edition38.com/forums there are normally a few 1.8T engines for sale.
AUM is drive by wire throttle so you'll be needing an AUM / AUQ. Not sure if ealier engines can be converted to DBW?
just realised i didnt actually post the link in my first reply....
search "QPENG" they have a table that shows all the 20vt applications and details which are DBW which arent which are VVT which arent etc.
Oh and you can convert non DBW to DBW by fitting the correct throttle body. AGU 150hp early 20vt engines were NOT DBW and have the bigger inlet/exhaust ports and better head design than later models.
dave
search "QPENG" they have a table that shows all the 20vt applications and details which are DBW which arent which are VVT which arent etc.
Oh and you can convert non DBW to DBW by fitting the correct throttle body. AGU 150hp early 20vt engines were NOT DBW and have the bigger inlet/exhaust ports and better head design than later models.
dave
Only way to test the turbo with the engine not drivable is to take a boost pipe off, the one that goes to the inlet part of the turbo, and feel the shaft, should rotate freely with no significant up/down play.
With no oil pressure long enough to nip up the cams, I would expect its either siezed solid and wont rotate or to have about 10mm of up and down movement.
As you say it may have been only the oil ways to the cams that were clogged, but thats not normally what happens in my experience.
Ask you dad, did a red picture of an oil-can come up on the dash.
Then show him this http://www.pistonheads.com/gassing/topic.asp?h=0&a...
With no oil pressure long enough to nip up the cams, I would expect its either siezed solid and wont rotate or to have about 10mm of up and down movement.
As you say it may have been only the oil ways to the cams that were clogged, but thats not normally what happens in my experience.
Ask you dad, did a red picture of an oil-can come up on the dash.
Then show him this http://www.pistonheads.com/gassing/topic.asp?h=0&a...
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


