What should my MGF window seals be like?
Discussion
The drivers window on my MGF leaks a little, I've adjusted it in and down and it leaks a lot less. The window sits on top of the door seals on the A pillar and hood, but the passenger window pushes into the seals and flattens the one on the A pillar (and is watertight).
Which side is right?
When I tried to get the window to do the same as the passenger side I couldn't open the door if I shut the door then wound the window up.
The window has obviously been changed at some point as there's broken glass in the bottom of the door.
Which side is right?
When I tried to get the window to do the same as the passenger side I couldn't open the door if I shut the door then wound the window up.
The window has obviously been changed at some point as there's broken glass in the bottom of the door.
The windows should sit tight in the roof sills, but you should still be able to open/close door without issues.
The only area where I get a very small water leak (but this is when I am using the pressure washer here) is the bottom corner where the hood meets the glass by the door locking pin, just a few splashes... never leaks during a down pour.
You may need to have look around http://www.mgf.ultimatemg.com
The only area where I get a very small water leak (but this is when I am using the pressure washer here) is the bottom corner where the hood meets the glass by the door locking pin, just a few splashes... never leaks during a down pour.
You may need to have look around http://www.mgf.ultimatemg.com
Gassing Station | MG | Top of Page | What's New | My Stuff