04 electronic switching exhaust
04 electronic switching exhaust
Author
Discussion

gsd2000

Original Poster:

11,515 posts

214 months

Saturday 26th June 2010
quotequote all
Why isnt there one?

Was it due to there being more 05+ monaros than 04 monaros?

Is it possible to fabricate one?

kiwifraser

4,388 posts

225 months

Saturday 26th June 2010
quotequote all
I think there just wasn't enough room to make it fit. Remember, on the 04 both pipes exit on the Left Hand Side.

the_ferret82

25,627 posts

215 months

Saturday 26th June 2010
quotequote all
gsd2000 said:
Why isnt there one?

Was it due to there being more 05+ monaros than 04 monaros?

Is it possible to fabricate one?
its called not enough room underneath due to the fuel tank being in its proper place.

there is a few posts on here from people who are looking at making there own..

gsd2000

Original Poster:

11,515 posts

214 months

Saturday 26th June 2010
quotequote all
How does the switching exhausts work?

Use a valve to bypass the silencer?

If so what about the centre box turn that into the loud/quiet switching area. Would that work?

It just had this idea whilst sitting under my 04 ro, as you do.

the_ferret82

25,627 posts

215 months

Saturday 26th June 2010
quotequote all
gsd2000 said:
How does the switching exhausts work?

Use a valve to bypass the silencer?

If so what about the centre box turn that into the loud/quiet switching area. Would that work?

It just had this idea whilst sitting under my 04 ro, as you do.
there is a pic of a switching exhaust a few posts back. that shows you wink

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

Edited by the_ferret82 on Saturday 26th June 23:40

kiwifraser

4,388 posts

225 months

Sunday 27th June 2010
quotequote all
It could be done relatively easily on an 04 by using cutouts, although be prepared for quiet/ superloud switching.

I removed the center boxes, and considered putting the cutouts where they were by using a y-pipe, then running side exits out in front of the rear wheel arches (possibly with a small silencer each side after the cutout). There is a lot of room once the center boxes are out.




You could always have no exit pipes, if it was only for short blasts with your exhaust running straight from the headers. [I know this isn't a Ro, but shows the idea]


QTP sell dual cutout kits including the y-pipe for about £250-£300 iirc.