ongoing abs fault
Author
Discussion

stigmundfreud

Original Poster:

22,454 posts

241 months

Thursday 1st July 2010
quotequote all
All

as you might be aware I have an abs sensor fault at present (off side rear) that even after being replaced is still occuring. It started off that under gentle driving, just pulling along in gear there was no issue. Any acceleration and it would trigger, take out TCS but all was ok. Now it has developed further, yesterday under conditions that should not provoke ABS, the ABS was kicking in. This to me is rather dangerous as ABS actually worsens braking under conditions where it should not come into effect. Bone dry, good grip, no excuses for it. It was intermittent.

To test, I found a nice flat bit of tarmac and braked hard from 30, no ABS kicking in, I then gently braked and it kicked in, this time on the braking the ABS fault occured so I can rule out accelration being the issue.

Any ideas? Vauxhall are taking the car in for a few days to investigate but I'm not totally convinced it is related to the sensor (how rare for a new sensor to fail within minutes with the same fault?). They are suggesting it could be the wiring loom but I am thinking something else, perhaps drive shaft or controller related.

Ideas would be good, ta.

Magic919

14,596 posts

232 months

Thursday 1st July 2010
quotequote all
Wheel bearing?

stigmundfreud

Original Poster:

22,454 posts

241 months

Thursday 1st July 2010
quotequote all
possible but no noticable sign of that. Suppose if the weather is nice on Saturday I'll lift it up and give it a try. What was more concering was yeserdays brake issue. Bearing surely shouldnt fail so soon?

satsuma71

177 posts

197 months

Thursday 1st July 2010
quotequote all
Had this on a customers car, was the abs pick up ring on the cv joint had cracked, and was intermittantly triggering the abs, new joint sorted it.

S800VXR

5,877 posts

231 months

Thursday 1st July 2010
quotequote all
My father had this on a new style S40. They replaced the whole hub setup after we had tried everytning and to be fair they did say at the start it will only be sorted by replacing the hub! eek
Never really got to the bottom of the reason but something to do with tolerences, IL chat to the old man tonight and try to refresh my memory for the reason mate as what your describing is exactly what he had.

stigmundfreud

Original Poster:

22,454 posts

241 months

Thursday 1st July 2010
quotequote all
cheers

the more ideas I can give the dealers the better. It has had the new sensor fitted, not sure what else they have checked but will give them a list and ask them to check it all out. Dont want this to turn into a 6 months without car affair

Magic919

14,596 posts

232 months

Thursday 1st July 2010
quotequote all
Bart had a wheel bearing, plus the hub as it was knackered.

stigmundfreud

Original Poster:

22,454 posts

241 months

Thursday 1st July 2010
quotequote all
Magic919 said:
Bart had a wheel bearing, plus the hub as it was knackered.
oh the fun filled ides i have of a hub failing on the motorway. Will pm him to see if he has a job number we can use as reference

satsuma71

177 posts

197 months

Thursday 1st July 2010
quotequote all
Other fault which comes up now and again is a poor connection at the abs sensor multiplug, again triggering the abs intermittantly.

S800VXR

5,877 posts

231 months

Friday 2nd July 2010
quotequote all
Update Stig.
The problem with the volvo was that the wheel bearing was worn a little (no real noise) and as such it was allowing the hub to move under load a little but it was enough to upset the sensors sometimes. Seems the volvo approach was to replace the whole hub as its not cost effective to replace the bearings due to the way they are assembled. I still find it hard to believe they are that sensitive to distance but it did work...