wiring question

[nightSpirit]

can someone tell me which wire at drivers fuse box is ign 3/start, ign 2 and illumination on a tam?

are the seats and fuse box easy to remove?

thanks chaps

[shep1001]

nightSpirit said:

can someone tell me which wire at drivers fuse box is ign 3/start, ign 2 and illumination on a tam?

are the seats and fuse box easy to remove?

thanks chaps

Seats are easy(ish) 4 13mm nuts. Just look under the car its clear which they are. The rear bolts are easy as they don't spin when you remove the nuts. The fronts can be a PITA as you need to hold the bolt head that sits in the seat rail to stop it spinning. Best done with two people unless you have long arms for the innermost bolt at the front.

I got the arse with mine and ground the nuts off and replaced the bolts as it was easier. 4 new Stainless bolts, plenty of copper slip and new nyloc's when you put them back in and they will be easy to remove in future.

Its easier without the roof on, you also need to un-bolt the seatbelt from the side of the seat when the bolts are out. Be careful not to drop the seat on the body as you lift it out as the bolts will makle a right mess of the body!

Shep

[nightSpirit]

thanks Shep!

Any idea on the wiring (voltmeter will tell me tomorrow)?

[shep1001]

nightSpirit said:

thanks Shep!

Any idea on the wiring (voltmeter will tell me tomorrow)?

Sorry no idea on that one.

[nightSpirit]

no matter shep, I'll know soon enough!