seat ibiza cupra
Discussion
Looking at these to buy in the next few months, would love to know what to look out for and budget around 3k. Do high miles have any impact on reliability?
A drove a cupra diesel and found the ride very firm...Any tips for upgrades on suspension as I understand the remap is a matter of course..
thanks
A drove a cupra diesel and found the ride very firm...Any tips for upgrades on suspension as I understand the remap is a matter of course..
thanks
sorry to hijack your post but I was wondering if one of these would make a good sprint/hillclimb car? Have seen a few modded ones running a claimed 200-230bhp so power to weight ratio should be good. Currently running a Clio 172 Cup but they are very hard (& expensive) to extract extra power from & few are getting anywhere near the claimed 170bhp from what I can gather.
The Spruce Goose said:
Looking at these to buy in the next few months, would love to know what to look out for and budget around 3k. Do high miles have any impact on reliability?
A drove a cupra diesel and found the ride very firm...Any tips for upgrades on suspension as I understand the remap is a matter of course..
thanks
Plenty of highly tuned Cupras on here http://www.seatcupra.net/ hthA drove a cupra diesel and found the ride very firm...Any tips for upgrades on suspension as I understand the remap is a matter of course..
thanks
well they use the same 20VT engine that has been used in VAG group cars for nearly 15years so apart from coil packs, oil pick up pipes and electric gubbins they are proven reliable and tunable.
The SeatCurpanet forum is a very good place to start searching for more info and details on spec etc.
One thing i found was the handling is a bit perculiar as the front track is wider than the rear, spacers can compensate for this but a rear ARB is a good upgrade to.
dave
The SeatCurpanet forum is a very good place to start searching for more info and details on spec etc.
One thing i found was the handling is a bit perculiar as the front track is wider than the rear, spacers can compensate for this but a rear ARB is a good upgrade to.
dave
nobodyknows said:
sorry to hijack your post but I was wondering if one of these would make a good sprint/hillclimb car? Have seen a few modded ones running a claimed 200-230bhp so power to weight ratio should be good. Currently running a Clio 172 Cup but they are very hard (& expensive) to extract extra power from & few are getting anywhere near the claimed 170bhp from what I can gather.
Surely a good hill climb car would be more like a sports car than a hot hatch? Personally I think you'd be fa better with an Elise than an ibiza! And iirc your beat hill climb cars are light, relatively low power not turbo hot hatches!Cost Captain said:
nobodyknows said:
sorry to hijack your post but I was wondering if one of these would make a good sprint/hillclimb car? Have seen a few modded ones running a claimed 200-230bhp so power to weight ratio should be good. Currently running a Clio 172 Cup but they are very hard (& expensive) to extract extra power from & few are getting anywhere near the claimed 170bhp from what I can gather.
Surely a good hill climb car would be more like a sports car than a hot hatch? Personally I think you'd be fa better with an Elise than an ibiza! And iirc your beat hill climb cars are light, relatively low power not turbo hot hatches!nobodyknows said:
that all depends on which class you want to enter. I am currently entering in Class A3 for Road Going Production Cars 1800-2600cc - with the 1.8T engine the Ibiza would just fit into the same class but offer far higher power to weight ratio than most road going production cars
Speak to Badger5 tuning then, Bill runs a circa 500hp Ibiza track car so he can tell you a thing or two about high power light weight Cupras!dave
Outside:
check for accident damage,
panel gaps,
rust(leading edge of roof, wings, rear quarters, arches)
mis-match paint,
expect stonechips on a 7/8/9/10 year old car, if there arent any, why not?
Engine bay:
Cupras are 156bhp 1.8t's in standard trim, all engine codes begin with A as far as i know, the code is under the plastic cover, near the cambelt at the top. these cars run a SMIC from the factory, its tiny and poo, alot have had FMIC's installed. check they have not removed the aircon in the process. they also run a plastic recirc, these split the internal rubber diaphram easily, and are also commonly replaced, the best standard replacement is a forge 007p, as a full dump valve confuses the managment. boost hoses pop off too and may also be changed. the air intake is in a woeful position behind the battery and alot of people run open filters which can cause heat sink, there isnt much you can do about this without putting the battery in the boot. when you tun the engine off you should be able to hear the secondary water pump, under the scuttle pannel.
Chassis:
Mk3 Ibizas are mk2/3 golf front end and polo 6n2 back end, as a result the rear beam is narrow comapred to the front end and alot of people run spacers (mine are 20mm with standard wheels an tyres, rubs with more than 2 in the car). for suspension as far as i know its ibiza specific, but there are murmurings of polo 6n2 stuff fitting. These cars run mk2 golf G60 brakes, which are shocking, decent disks an pads help a bit, but really you need bigger ones for anything over stage one. cupra R brembos are a common swap, Ksport Racing make a kit for the corrado G60 which fits for the same price. Audi TT 312's can also be made to fit.
Interiour:
Cupras have half leather seats, watch for bolster wear, and stained centres, these seats also have side impact airbags in. the airvents are fixed into the dash and are not changable except for removing alot of other stuff, so watch for broken ones. the centre console uses a communal screen for A/C and stereo, these are prone to failing and are expensive to replace, so make sure it ALL works and your A/C is icy cold. standard audio is a radio/tape/6cd changer (in the boot)some owners fit another headunit under the steering wheel. if there are signs that this is the case, but the headunit is no longer there, check the original centre unit a few times when seeing the car, dodgy wiring might show up on a test drive after being shaken about. make sure your elec windows and mirrors are fully functioning.
hope this helps!!!!!
Al.
^stolen from myself, i have one, fully polybushed, poly engine mounts and a decent suspension kit, 20mm rear spacers. with good tyres (well, T1R's) there is ALOT of grip for a FWD car. they weigh in at 1170kgs. so in a good stage 1 trim, will be just under 200bhp/tonne.
check for accident damage,
panel gaps,
rust(leading edge of roof, wings, rear quarters, arches)
mis-match paint,
expect stonechips on a 7/8/9/10 year old car, if there arent any, why not?
Engine bay:
Cupras are 156bhp 1.8t's in standard trim, all engine codes begin with A as far as i know, the code is under the plastic cover, near the cambelt at the top. these cars run a SMIC from the factory, its tiny and poo, alot have had FMIC's installed. check they have not removed the aircon in the process. they also run a plastic recirc, these split the internal rubber diaphram easily, and are also commonly replaced, the best standard replacement is a forge 007p, as a full dump valve confuses the managment. boost hoses pop off too and may also be changed. the air intake is in a woeful position behind the battery and alot of people run open filters which can cause heat sink, there isnt much you can do about this without putting the battery in the boot. when you tun the engine off you should be able to hear the secondary water pump, under the scuttle pannel.
Chassis:
Mk3 Ibizas are mk2/3 golf front end and polo 6n2 back end, as a result the rear beam is narrow comapred to the front end and alot of people run spacers (mine are 20mm with standard wheels an tyres, rubs with more than 2 in the car). for suspension as far as i know its ibiza specific, but there are murmurings of polo 6n2 stuff fitting. These cars run mk2 golf G60 brakes, which are shocking, decent disks an pads help a bit, but really you need bigger ones for anything over stage one. cupra R brembos are a common swap, Ksport Racing make a kit for the corrado G60 which fits for the same price. Audi TT 312's can also be made to fit.
Interiour:
Cupras have half leather seats, watch for bolster wear, and stained centres, these seats also have side impact airbags in. the airvents are fixed into the dash and are not changable except for removing alot of other stuff, so watch for broken ones. the centre console uses a communal screen for A/C and stereo, these are prone to failing and are expensive to replace, so make sure it ALL works and your A/C is icy cold. standard audio is a radio/tape/6cd changer (in the boot)some owners fit another headunit under the steering wheel. if there are signs that this is the case, but the headunit is no longer there, check the original centre unit a few times when seeing the car, dodgy wiring might show up on a test drive after being shaken about. make sure your elec windows and mirrors are fully functioning.
hope this helps!!!!!
Al.
^stolen from myself, i have one, fully polybushed, poly engine mounts and a decent suspension kit, 20mm rear spacers. with good tyres (well, T1R's) there is ALOT of grip for a FWD car. they weigh in at 1170kgs. so in a good stage 1 trim, will be just under 200bhp/tonne.
Edited by JB! on Thursday 29th July 15:27
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


