A3 8P 3.2 Fault Code - TAME TECHNICIAN
A3 8P 3.2 Fault Code - TAME TECHNICIAN
Author
Discussion

Cost Captain

Original Poster:

3,920 posts

211 months

Sunday 25th July 2010
quotequote all
Engine management light came on in my A3 on friday night, got it on the diagnostics at work yesterday and came back with a fault code but we're a tad confused by what it means!!

"Mixture correction (bank 2) lean: P2098"

assuming it is lambda sensor related judging by mixture correction.

Any help would be greatly appreciated!

Cost Captain

Original Poster:

3,920 posts

211 months

Tuesday 27th July 2010
quotequote all
bumpetty bump

Tame Technician

2,467 posts

235 months

Tuesday 27th July 2010
quotequote all
Bank 2 Means cylinders 4 5 6, the three nearest the gearbox end of the engine.

Could be any of the usual causes of running lean, air leak from vac or breather pipe etc,

Or it could just be the lambda probe misreading.

Check the live data for lambda output and short term fuel trim, see what they are doing with the engine at idle, Fuel trim +% means its lean -% means its rich. Should be between -5% and + 5%. To log that fault would have to be over +20% on that bank.

Look at teh fuel trims see what they are doing and then spray a load of brake cleaner arround the inlet manifold and all vacuum connections, if the fuel trim suddenly drops, say from +20% to like -20% when you spray, you have found you air leak.

Check the connections at the lambda probes they can get full of water and corroide. If you suspect a probe you could swap it with the one from bank one, if the fault still occurs for bank two, you know its not the sensor, if the fault moves to bank one with the sensor swap, then its the sensor misreading.


Cost Captain

Original Poster:

3,920 posts

211 months

Wednesday 28th July 2010
quotequote all
Thanks for that will have a play with the diagnostics when I get a chance.

But the situation has magnified, slight blow on the exhaust turns out to be both flexies are utterly shagged! Looking at it, the bottom engine mount has alot of movement, but doesn't look split, is this a common thing?or are they meant to move a lot? Would make sense ifthe engine mount has gone and that has killed the flexes!

Tame Technician

2,467 posts

235 months

Wednesday 28th July 2010
quotequote all
That will be it if the flexi damage is nearer the engine than the lambda probes.

An exhaust leak will let oxygen from the outside air into the exhaust and confuse the lambda probe (which is after all an oxygen sensor)