Audi 80 TDi hunting at idle
Discussion
Hopefully someone can give some suggestions, it's an old 1994 beast with 217k on the clock and has run fine for the 5000 miles i've done in the last 2 and a bit months. However this morning once it started it hunts on idle between 800 and 1400 rpm and as it's an auto this means interesting times in traffic.
my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
thanks in advance
my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
thanks in advance
not sure if the tdi has an Idle Stablisation Valve but these are a solenoid which can get really sticky had it in my 80quattro.
http://www.20v.org/engprob.htm
Give it a bloody good clean to establish if thats the issue.
http://www.20v.org/engprob.htm
Give it a bloody good clean to establish if thats the issue.
[quote=7ommy
my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
[/quote]
missed that bit, not too old for diagnostics, just the older 2x2 port. A garage should be able to read it for you, i would get that done first.
my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
[/quote]
missed that bit, not too old for diagnostics, just the older 2x2 port. A garage should be able to read it for you, i would get that done first.
istoo said:
[quote=7ommy
my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
missed that bit, not too old for diagnostics, just the older 2x2 port. A garage should be able to read it for you, i would get that done first. my friend offered to use his vag com on it but its too old and has the twin plug diagnostic port and wondered if anyone here had some ideas
You are right of course, and my equipment can diagnose that 7ommy. The only problem is you will have to make it up to Glasgow!!
The OP could of course make a blink code reader, if you can be bothered! £3 from maplins will do it.
http://20v.org/tools.htm
Doing good thanks, Jith fae Glasgow... hmmm could be a few people and I dont recognise the username! go on give us a clue.
http://20v.org/tools.htm
Doing good thanks, Jith fae Glasgow... hmmm could be a few people and I dont recognise the username! go on give us a clue.
istoo said:
The OP could of course make a blink code reader, if you can be bothered! £3 from maplins will do it.
http://20v.org/tools.htm
Doing good thanks, Jith fae Glasgow... hmmm could be a few people and I dont recognise the username! go on give us a clue.
Iolaire from Audifans. http://20v.org/tools.htm
Doing good thanks, Jith fae Glasgow... hmmm could be a few people and I dont recognise the username! go on give us a clue.
istoo said:
Sorry OP...
oh likewise, hope your keeping well sir. Did you kick your garage project off the ground and start a business?
I did that. Have a look at my profile and it will take you into the website.oh likewise, hope your keeping well sir. Did you kick your garage project off the ground and start a business?
Lots of nice motors. Pop in and see me next time you're in Glasgow.
Regards,
James.
istoo said:
The vac hoses go very brittle, and block very easy. if original 200k+ is a good innings!
I would replace them all as a matter of course.
the 1Z engine will go and go, I know a fair few over 200k and some over 300k!
Mine had 255k when sold, its a great engine, but take a look at the fuel pump governer will you, mine hunted like a good one until the specialist dealt with it.I would replace them all as a matter of course.
the 1Z engine will go and go, I know a fair few over 200k and some over 300k!
k
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


