Diesel Starting problem
Discussion
Looking to see if anyone can help with this problem I have
Rebuilt diesel engine up in a A4 got it all in started it up fine no problem then the next day went to get it going and no joy at all have checked timing to see if it had slipped a tooth but all good , fuel getting to injectors but the glow plugs dont seem to be getting power , check relay first and its fine ..Its like it has immobiliser fault of some sort as it turnover it like it wants to start but just wont , have run a live feed through the glow plugs just to see if I could get it to go but same thing , it offers but just doesnt run ...VAG.com does show anything
Have swapped over ecu and the things that you would think it would be but still pinning it down to immob
Is there a way to cancel this out or is there a relay that I am missing
Cheers
Steve
Rebuilt diesel engine up in a A4 got it all in started it up fine no problem then the next day went to get it going and no joy at all have checked timing to see if it had slipped a tooth but all good , fuel getting to injectors but the glow plugs dont seem to be getting power , check relay first and its fine ..Its like it has immobiliser fault of some sort as it turnover it like it wants to start but just wont , have run a live feed through the glow plugs just to see if I could get it to go but same thing , it offers but just doesnt run ...VAG.com does show anything
Have swapped over ecu and the things that you would think it would be but still pinning it down to immob
Is there a way to cancel this out or is there a relay that I am missing
Cheers
Steve
If it was an immobiliser, vagcom would say so - 01 engine section "Engine start blocked by immobiliser" is the usual thing to come up.
Time to get that key coded. Can be done with vagcom if you have the 4 digit pin to access the ECU (normally supplied in a plastic tab with the spare car keys when you first buy the car from new)
have to say it is odd it was working one day, not the next. Equally odd there are no fault codes stored either. If it turns out the immob coding is fine, not sure where next step is. Maybe the PD injector wiring loom is faulty? (I have two spare if you need one
)
Time to get that key coded. Can be done with vagcom if you have the 4 digit pin to access the ECU (normally supplied in a plastic tab with the spare car keys when you first buy the car from new)have to say it is odd it was working one day, not the next. Equally odd there are no fault codes stored either. If it turns out the immob coding is fine, not sure where next step is. Maybe the PD injector wiring loom is faulty? (I have two spare if you need one
)Edited by TDIfurby on Thursday 29th July 23:18
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


