Need Audi Technician's help with CVT
Discussion
I have a 2002 A4 with a CVT transmission. I'm currently getting the following error code from the transmission, code 18185 / P1777.
According to the repair manual the possible cause for the error code can be caused by one of the following three problems;
1)in-line filter clogged
2)restriction in the oil lines
3)TCM faulty
I have replaced the in-line filter and checked the oil lines for restrictions and did not find any restrictions. So it appears to be the TCM.
The transmission works good when cold but after it warms up (from driving for about 30 - 45 minutes) there is a delay in moving forward and when it does start to engage it is very abrupt (slam into gear) when starting from stand still. After the car starts moving the transmission works fine until you come to a complete stop then the delay in moving and engaging abruptly is repeated.
Are there any checks that I can perform to ensure that the TCM is bad?
I do have a vag-com cable from Ross-Tech so I can check different measuring block of the CVT.
Appreciate any help.
According to the repair manual the possible cause for the error code can be caused by one of the following three problems;
1)in-line filter clogged
2)restriction in the oil lines
3)TCM faulty
I have replaced the in-line filter and checked the oil lines for restrictions and did not find any restrictions. So it appears to be the TCM.
The transmission works good when cold but after it warms up (from driving for about 30 - 45 minutes) there is a delay in moving forward and when it does start to engage it is very abrupt (slam into gear) when starting from stand still. After the car starts moving the transmission works fine until you come to a complete stop then the delay in moving and engaging abruptly is repeated.
Are there any checks that I can perform to ensure that the TCM is bad?
I do have a vag-com cable from Ross-Tech so I can check different measuring block of the CVT.
Appreciate any help.
[quote=swagemarare there any checks that I can perform with the vag-com cable on the TCM to ensure that it's faulty.
[/quote]
Not really no.
Without actually seening the description of that fault from the Audi 5051, I cant tell you 100% what it means, but its either; No comms between TCM and ECM, (engine runs so ECM is ok) which means a knacker TCM,
Or its a pressure sensor, or switch position fault, both are built into the TCM so thats a knackered TCM also.
If you are really concerned, you can find an auto trans specialist (who can/does do multi tronics) you could pay £50 or so, just to have them confirm it, before you shell out for a new Gearbox ECU (TCM)
[/quote]
Not really no.
Without actually seening the description of that fault from the Audi 5051, I cant tell you 100% what it means, but its either; No comms between TCM and ECM, (engine runs so ECM is ok) which means a knacker TCM,
Or its a pressure sensor, or switch position fault, both are built into the TCM so thats a knackered TCM also.
If you are really concerned, you can find an auto trans specialist (who can/does do multi tronics) you could pay £50 or so, just to have them confirm it, before you shell out for a new Gearbox ECU (TCM)
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


