Eneven ride height
Discussion
Had the wheels off the rear of the car last week to check the diff, CV and suspension bolts. When I lowered the car back down I noticed that the passenger side was sitting noticably higher than the drivers side (probably by about 1cm) but assumed this would bed back down once I took the car for a drive.
Anyway went out for a drive yesterday which made no difference. On closer inspection it appears that the passenger side spring is compressed by about 3 turns more than the drivers side. The Shocks are Gaz Golds. Not sure why this is the case, the car was recently re-build after a chassis refurb and i'm pretty sure the ride heght was even after the rebuild.
To adjust the ride height I assume I just need to slacken of the adjuster ring and measure the ride height from the corner of the outrigger. I believe 150mm front and 160mm rear is about right. Guess I will also need to get the Geometry set up checked afterwards.
Anyway went out for a drive yesterday which made no difference. On closer inspection it appears that the passenger side spring is compressed by about 3 turns more than the drivers side. The Shocks are Gaz Golds. Not sure why this is the case, the car was recently re-build after a chassis refurb and i'm pretty sure the ride heght was even after the rebuild.
To adjust the ride height I assume I just need to slacken of the adjuster ring and measure the ride height from the corner of the outrigger. I believe 150mm front and 160mm rear is about right. Guess I will also need to get the Geometry set up checked afterwards.
just checked the heights (outer triangular outrigger plate to ground)
Front NS - 145mm
Front OS - 145mm
Rear NS - 155
Rear OS - 145
So based on recomended settings from a few posts on here on here, it looks like the drivers side height actually needs lifting rahter than the Passenger side lowering. Problem is the visually the passenger side seems to sit far too high. see pics below.

Near Side

Off Side
Will check again tomorow when the car is back in the garage on level Ground.
Front NS - 145mm
Front OS - 145mm
Rear NS - 155
Rear OS - 145
So based on recomended settings from a few posts on here on here, it looks like the drivers side height actually needs lifting rahter than the Passenger side lowering. Problem is the visually the passenger side seems to sit far too high. see pics below.

Near Side

Off Side
Will check again tomorow when the car is back in the garage on level Ground.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




